ResumoA resistividade elétrica superficial é um parâmetro interessante para controlar a vida útil de estruturas de concreto, principalmente devido à praticidade de execução do ensaio. O objetivo deste artigo é comparar a resistividade elétrica superficial (RES) de concretos com dois diferentes tipos de cimento: um com adição de pozolana (CP IV) e outro sem adição mineral (CP V). A RES foi medida pelo método de Wenner. Foi utilizado o mesmo traço 1:1,4:2,1 (cimento: areia: brita) e a mesma relação água/cimento de 0,50 para os dois tipos de concreto investigados. Os resultados foram analisados nas idades de 28, 60, 90, 120, 150 e 180 dias. Para todas as amostras foi identificado um aumento da RES com o tempo de ensaio. Porém, no cimento com adição de pozolana, o fator idade do concreto elevou-se 93% em relação ao fator idade das amostras de CP V. A RES foi muito superior para o concreto de cimento com adição pozolânica em todas as idades, atingindo valor 4,9 vezes maior que amostra de concreto com cimento CP V aos 180 dias.Palavras-Chave: Concreto; Resistividade elétrica superficial; Pozolana. AbstractThe surface electrical resistivity is an interesting parameter to control the useful life of concrete structures, mainly due to the practicality of the test. The aim of this study was to evaluate the change in surface electrical resistivity (SER) of concretes produced with two different types of cement: a cement with pozzolan (CP IV) and a cement without addition (CP V). It was used the same proportion between materials and the same water/cement ratio for the samples. The SER was measured using the Wenner Method for 28, 60, 90, 120, 150 and 180 days. The results indicated that the SER increased with time for both types of cement, although the age factor of the concrete with CP IV was 93% higher. This concrete had better results in every age and it was almost five times greater for 180 days when comparing with samples produced with CP V.
Resumo: Ao pensar em projetar estruturas de concreto a partir do conceito de durabilidade, a resistividade elétrica torna-se um parâmetro interessante para controle de vida útil, principalmente devido à praticidade de execução do ensaio, caracterizado como não destrutivo. A resistividade é definida como a habilidade do material em transportar cargas elétricas no seu interior, ou seja, no caso do concreto, de difundir os íons através da solução aquosa presente em seus poros. Relacionada à permeabilidade, a resistividade é um indicativo da resistência do concreto à penetração de agentes agressivos, a qual, consequentemente, afeta a velocidade de corrosão das armaduras do concreto. O objetivo deste artigo é comparar a resistividade elétrica superficial (RES) de concretos com dois diferentes tipos de cimento: um com adição de escória de alto forno durante a composição (CP III RS) e outro sem esse tipo de adição (CP V). A RES foi medida pelo método dos quatro pontos. Foi utilizado o mesmo traço 1:1,4:2,1 (cimento: areia: brita) e a mesma relação água/cimento de 0,50 para as duas amostras de concreto investigadas. Os resultados foram analisados nas idades de 28, 60, 90, 120, 150 e 180 dias. Para os concretos com ambos os tipos de cimento foi identificado um aumento da RES com o tempo de ensaio. Porém, no cimento com adição de escória, o fator idade do concretoparâmetro que mede o crescimento da resistividade no tempo -elevou-se 45% em relação ao fator idade das amostras de CP V. A RES foi muito superior para o concreto com cimento de escória de alto forno em todas as idades, atingindo valor 9,7 vezes maior que amostra de concreto com cimento CP V aos 180 dias.Palavras-chave: concreto, resistividade elétrica superficial, escória de alto forno. Abstract:The electrical resistivity is an interesting parameter of service life when thinking of durability of concrete structures, mainly due to the practicality of a non-destructive test method. In the case of concrete, it is defined as the material's ability to transport electric charges by diffusing the ions through the aqueous solution present in its pores. The electrical resistivity indicates the resistance of concrete to the penetration of aggressive agents that may cause corrosion of reinforcement. There are many factors that act directly on this parameter as the microstructure of concrete, the chemical composition of cement, the amount of water used in the mix and the proportion between materials. The aim of this study was to evaluate the change in surface electrical resistivity (SER) of concretes produced with two different types of cement: the blast-furnace slag cement (CP III RS) and a cement without this addition (CP V). It was used the same proportion between materials and the same water/cement ratio for the samples. The SER was measured using the Werner Method (four-point method) for 28, 60, 90, 120, 150 and 180 days. The results indicated that the SER increased with time for both types of cement, although the age factor -parameter that measures the development in ...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.