A fast and straightforward generic procedure for the simultaneous extraction of various classes of pesticides, mycotoxins, plant toxins, and veterinary drugs in various matrixes has been developed, for subsequent analysis by liquid chromatography with mass spectrometric detection. As a first step, four existing multianalyte procedures and three newly proposed methods were compared for a test set of 172 pesticides, mycotoxins, and plant toxins spiked to a feed matrix. The new procedures, which basically involved extraction/dilution of the sample with water and an acidified organic solvent (methanol, acetonitrile, or acetone), were most promising. The three new generic extraction methods were further tested for applicability to other matrixes (maize, honey, milk, egg, meat). Overall, the best recoveries were obtained for acetone, followed by acetonitrile. With respect to matrix effects, acetonitrile was the most favorable solvent and methanol was the worst. The occurrence of matrix effects decreased for the matrixes in the order of feed > maize > meat > milk > egg > honey. The extraction method selected as the default procedure (water/acetonitrile/1% formic acid) was also evaluated for applicability to multiple classes of veterinary drugs in all six matrixes, with satisfactory results. Finally, the generic extraction procedure was validated for 136 pesticides, 36 natural toxins, and 86 veterinary drugs in compound feed and honey at three levels (0.01, 0.02, and 0.05 mg/kg) using ultraperformance liquid chromatography tandem mass spectrometry (UPLC-MS/MS) for analysis of the extracts. For over 80% of the analytes, recoveries were between 70 and 120% and precision (expressed as relative standard deviation) was mostly in the range of 5-10% (except for feed at 0.01 mg/kg; adequate recoveries for 62% of the analytes). The limits of detection were from <0.01 to 0.05 mg/kg for most analytes, which is usually sufficient to verify compliance of products with legal tolerances. The results clearly demonstrate the feasibility of the generic approach proposed. Application of the method in routine monitoring programs would imply a drastic reduction of both effort and time.

No abstract

No abstract

Two methods, one to determine ascorbic acid and one to determine lycopene and beta-carotene, in vegetables and fruits by liquid chromatography coupled with mass spectrometry (LC-MS) have been established. The chromatographic separation of the studied compounds and their MS parameters were optimized to improve selectivity and sensitivity. In both methods, separation was carried out with two coupled columns, first a C(18) and then a dC(18), using as mobile phase 70% methanol (0.005% acetic acid) and 30% acetic acid 0.05% for ascorbic acid determination and a mixture of methanol, tetrahydrofuran, and acetonitrile (60:30:10 v/v/v) for carotenoid analysis in isocratic mode. The molecular ion was selected for the quantification in selective ion monitoring (SIM) mode. Ascorbic acid was detected with electrospray ionization probe (ESI) in negative mode, while chemical ionization atmospheric pressure (APCI) in positive mode was used for the target carotenoids. The methodology for ascorbic acid analysis is based on an extraction with polytron using methanol and a mixture of methaphosphoric acid and acetic acid. Extraction of the carotenoids was carried out with tetrahydrofuran/methanol (1:1) (v/v). The proposed methods were applied, after their corresponding validations, to the analysis of four varieties of tomatoes, tomato in tin enriched and dried tomato, and to the analysis of mango and kiwi fruits, to compare the content in these compounds. Moreover, the influence of the process of freezing and the effect that the manipulation/preservation has in the content of ascorbic acid in tomato have also been studied.

A rapid multi-analyte method has been developed for the simultaneous determination of pesticides and mycotoxins in milk by ultra high-performance liquid chromatography coupled to triple quadrupole mass spectrometry (UHPLC-QqQ-MS/MS). A variety of methodologies has been evaluated, including solid-phase extraction (SPE), "dilute-and-shoot" (liquid-liquid extraction-based procedures), and QuEChERS (quick, easy, cheap, effective, rugged, and safe)-based methods. The optimization and development process was carried out considering that the maximum residue level for aflatoxin M1 (AFM1) in milk in the European Union (EU) is set at 0.05 μg kg(-1), which is the lowest tolerance in the target compounds. The selected method consisted of an extraction by SPE using C18 as sorbent and methanol as elution solvent. The final determination was performed by UHPLC-QqQ-MS/MS. Matrix-matched standard calibration was used for quantification, obtaining recoveries in the range 60-120% with relative standard deviations <25%, at three spiking levels: 0.5, 10, and 50 μg kg(-1) (ten times lower for AFM1). Limits of quantification ranged from 0.20 to 0.67 μg kg(-1), which were always below or equal to the established tolerance levels by the EU. Finally, the selected method was applied to different types of milk.

No abstract

No abstract

No abstract