Liquid cell transmission electron microscopy (LCTEM) can provide direct observations of solution-phase nanoscale materials, and holds great promise as a tool for monitoring dynamic self-assembled nanomaterials. Control over particle behavior within the liquid cell, and under electron beam irradiation, is of paramount importance for this technique to contribute to our understanding of chemistry and materials science at the nanoscale. However, this type of control has not been demonstrated for complex, organic macromolecular materials, which form the basis for all biological systems and all of polymer science, and encompass important classes of advanced porous materials. Here we show that by controlling the liquid cell membrane surface chemistry and electron beam conditions, the dynamics and growth of metal-organic frameworks (MOFs) can be observed. Our results demonstrate that hybrid organic/inorganic beam-sensitive materials can be analyzed with LCTEM and, at least in the case of ZIF-8 dynamics, the results correlate with observations from bulk growth or other standard synthetic conditions. Furthermore, we show that LCTEM can be used to better understand how changes to synthetic conditions result in changes to particle size. We anticipate that direct, nanoscale imaging by LCTEM of MOF nucleation and growth mechanisms may provide insight into controlled MOF crystal morphology, domain composition, and processes influencing defect formation.

Over the past few years, in situ transmission electron microscopy (TEM) studies of lithium ion batteries using an open-cell configuration have helped us to gain fundamental insights into the structural and chemical evolution of the electrode materials in real time. In the standard open-cell configuration, the electrolyte is either solid lithium oxide or an ionic liquid, which is point-contacted with the electrode. This cell design is inherently different from a real battery, where liquid electrolyte forms conformal contact with electrode materials. The knowledge learnt from open cells can deviate significantly from the real battery, calling for operando TEM technique with conformal liquid electrolyte contact. In this paper, we developed an operando TEM electrochemical liquid cell to meet this need, providing the configuration of a real battery and in a relevant liquid electrolyte. To demonstrate this novel technique, we studied the lithiation/delithiation behavior of single Si nanowires. Some of lithiation/delithation behaviors of Si obtained using the liquid cell are consistent with the results from the open-cell studies. However, we also discovered new insights different from the open cell configuration-the dynamics of the electrolyte and, potentially, a future quantitative characterization of the solid electrolyte interphase layer formation and structural and chemical evolution.

We present a critical review of methods for defining the chemical environment during liquid cell electron microscopy investigation of electron beam induced nanomaterial growth and degradation. We draw from the radiation chemistry and liquid cell electron microscopy literature to present solution chemistry and electron beam-based methods for selecting the radiolysis products formed and their relative amount during electron irradiation of liquid media in a transmission electron microscope. We outline various methods for establishing net oxidizing or net reducing reaction environments and propose solvents with minimal overall production of radicals under the electron beam. Exemplary liquid cell electron microscopy experiments in the fields of nanoparticle nucleation, growth, and degradation along with recommendations for best practices and experimental parameters are reported. We expect this review will provide researchers with a useful toolkit for designing general chemistry and materials science liquid cell electron microscopy experiments by 'directing' the effect of the electron beam to understand fundamental mechanisms of dynamic nanoscale processes as well as minimizing radiation damage to samples.

One of the experimental challenges in the study of nanomaterials in liquids in the (scanning) transmission electron microscope ((S)TEM) is gaining quantitative information. A successful experiment in the fluid stage will depend upon the ability to plan for sensitive factors such as the electron dose applied, imaging mode, acceleration voltage, beam-induced solution chemistry changes, and the specifics of solution reactivity. In this paper, we make use of a visual approach to show the extent of damage of different instrumental and experimental factors in liquid samples imaged in the (S)TEM. Previous results as well as new insights are presented to create an overview of beam-sample interactions identified for changing imaging and experimental conditions. This work establishes procedures to understand the effect of the electron beam on a solution, provides information to allow for a deliberate choice of the optimal experimental conditions to enable quantification, and identifies the experimental factors that require further analysis for achieving fully quantitative results in the liquid (S)TEM.

Development of novel electrolytes with increased electrochemical stability is critical for the next generation battery technologies. In situ electrochemical fluid cells provide the ability to rapidly and directly characterize electrode/electrolyte interfacial reactions under conditions directly relevant to the operation of practical batteries. In this paper, we have studied the breakdown of a range of inorganic/salt complexes relevant to state-of-the-art Li-ion battery systems by in situ (scanning) transmission electron microscopy ((S)TEM). In these experiments, the electron beam itself caused the localized electrochemical reaction that allowed us to observe electrolyte breakdown in real-time. The results of the in situ (S)TEM experiments matches with previous stability tests performed during battery operation and the breakdown products and mechanisms are also consistent with known mechanisms. This analysis indicates that in situ liquid stage (S)TEM observations could be used to directly test new electrolyte designs and identify a smaller library of candidate solutions deserving of more detailed characterization. A systematic study of electrolyte degradation is also a necessary first step for any future controlled in operando liquid (S)TEM experiments intent on visualizing working batteries at the nanoscale.

In this paper we present in situ transmission electron microscopy (TEM) of synthetic polymeric nanoparticles with emphasis on capturing motion in a solvated, aqueous state. The nanoparticles studied were obtained from the direct polymerization of a Pt(II)-containing monomer. The resulting structures provided sufficient contrast for facile imaging in situ. We contend that this technique will quickly become essential in the characterization of analogous systems, especially where dynamics are of interest in the solvated state. We describe the preparation of the synthetic micellar nanoparticles together with their characterization and motion in liquid water with comparison to conventional electron microscopy analyses.

The development of new reverse osmosis (RO) membranes with enhanced performance would benefit from a detailed knowledge of the membrane structures which participate in the filtration process. Here, we examined the hierarchical structures of the polyamide (PA) active layer of the SW30HR RO membrane. Scanning electron microscopy combined with focused ion beam milling (FIB-SEM) was used to obtain the 3-D reconstructions of membrane morphology with 5 nm cross-sectional resolution (comparable with the resolution of low magnification TEM imaging in 2D) and 30 nm slice thickness. The complex folding of the PA layer was examined in 3 dimensions, enabling the quantification of key structural properties of the PA layer, including the local thickness, volume, surface area and their derivatives. The PA layer was found to exhibit a much higher and convoluted surface area than that estimated via atomic force microscopy (AFM). Cross-sectional scanning transmission electron microscopy (STEM) was used to observe the distribution of a tracer stain under various conditions. The behaviour of stain in dry and wet PA indicated that the permeation pathways have a dynamic nature and are activated by water. High resolution STEM imaging of the stained PA nano-films revealed the presence of <1 nm pore-like structures with a size compatible with free volume estimations by positron annihilation lifetime spectroscopy (PALS). This study presents a comprehensive map of the active PA layer across different length scales (from micro- to sub-nanometre) and mechanistic insight into their role in the permeation process

High energy electrons are used to generate homogeneously distributed nanometric Ce(iii) particles in situ avoiding large excesses of chemical reagents.