The increase or decrease in isometric force following active muscle lengthening or shortening, relative to a reference isometric contraction at the same muscle length and level of activation, are referred to as residual force enhancement (rFE) and residual force depression (rFD), respectively. The purpose of these experiments was to investigate the trainability of rFE and rFD on the basis of serial sarcomere number (SSN) alterations to history-dependent force properties. Maximal rFE/rFD measures from the soleus and extensor digitorum longus (EDL) of rats were compared after 4 weeks of uphill or downhill running with a no-running control. SSN adapted to the training: soleus SSN was greater with downhill compared with uphill running, while EDL demonstrated a trend towards more SSN for downhill compared with no running. In contrast, rFE and rFD did not differ across training groups for either muscle. As such, it appears that training-induced SSN adaptations do not modify rFE or rFD at the whole-muscle level.

Increased serial sarcomere number (SSN) has been observed in rats following downhill running training due to the emphasis on active lengthening contractions; however, little is known about the influence on dynamic contractile function. Therefore, we employed 4 weeks of weighted downhill running training in rats, then assessed soleus SSN and work loop performance. We hypothesised trained rats would produce greater net work output during work loops due to a greater SSN. Thirty-one Sprague-Dawley rats were assigned to a training or sedentary control group. Weight was added during downhill running via a custom-made vest, progressing from 5–15% body mass. Following sacrifice, the soleus was dissected, and a force-length relationship was constructed. Work loops (cyclic muscle length changes) were then performed about optimal muscle length (LO) at 1.5–3-Hz cycle frequencies and 1–7-mm length changes. Muscles were then fixed in formalin at LO. Fascicle lengths and sarcomere lengths were measured to calculate SSN. Intramuscular collagen content and crosslinking were quantified via a hydroxyproline content and pepsin-solubility assay. Trained rats had longer fascicle lengths (+13%), greater SSN (+8%), and a less steep passive force-length curve than controls (P<0.05). There were no differences in collagen parameters (P>0.05). Net work output was greater (+78–209%) in trained than control rats for the 1.5-Hz work loops at 1 and 3-mm length changes (P<0.05), however, net work output was more related to maximum specific force (R2=0.17-0.48, P<0.05) than SSN (R2=0.03-0.07, P=0.17-0.86). Therefore, contrary to our hypothesis, training-induced sarcomerogenesis likely contributed little to the improvements in work loop performance. This article has an associated First Person interview with the first author of the paper.

50The increase or decrease in isometric force following active muscle lengthening or shortening, 51 relative to a reference isometric contraction at the same muscle length and level of activation, are 52 referred to as residual force enhancement (rFE) and residual force depression (rFD), respectively. 53The purpose of these experiments was to gain further mechanistic insight into the trainability of 54 rFE and rFD, on the basis of serial sarcomere number (SSN) alterations to length-dependent 55properties. Maximal rFE/rFD measures from the soleus and extensor digitorum longus (EDL) of 56 rats were compared after 4 weeks of uphill/downhill running and a no running control. Serial 57 sarcomere numbers adapted to the training: soleus serial sarcomere number was greater with 58 downhill compared to uphill running, while EDL demonstrated a trend towards more serial 59 sarcomeres for downhill compared to no running. In contrast, absolute and normalized rFE/rFD 60 did not differ across training groups for either muscle. As such, it appears that training-induced 61 SSN adaptations do not modify rFE/rFD at the whole-muscle level. 62 63 65

No abstract

Introduction: The passive mechanical behavior of skeletal muscle represents both important and generally underappreciated biomechanical properties with little attention paid to their trainability. These experiments were designed to gain insight into the trainability of muscle passive mechanical properties in both single fibers and fiber bundles. Methods: Rats were trained in two groups: 4 weeks of either uphill (UH) or downhill (DH) treadmill running; with a third group as sedentary control. After sacrifice, the soleus (SOL), extensor digitorum longus (EDL), and vastus intermedius (VI) were harvested. One hundred seventy-nine bundles and 185 fibers were tested and analyzed using a cumulative stretchrelaxation protocol to determine the passive stress and elastic modulus. Titin isoform expression was analyzed using sodium dodecyl sulfate vertical agarose gel electrophoresis (SDS-VAGE). Results: Single fibers: passive modulus and stress were greater for the EDL at sarcomere lengths (SLs) ≥ 3.7 μm (modulus) and 4.0 μm (stress) with DH training compared to UH training and lesser for the SOL (SLs ≥ 3.3 μm) with DH training compared with control; there was no effect of UH training. Vastus intermedius was not affected by either training protocol. Fiber bundles: passive modulus and stress were greater for the EDL at SLs ≥ 2.5 μm (modulus) and 3.3 μm (stress) in the DH training group as compared with control, while no affects were observed in either the SOL or VI for either training group. No effects on titin isoform size were detected with training. Conclusion: This study demonstrated that a trainability of passive muscle properties at both the single fiber and fiber bundle levels was not accompanied by any detectable changes to titin isoform size.