No abstract

We describe a series of experiments performed to study the shock structure generated during the implosion of a gas-puff Z-pinch. The Z-pinch is produced by a double-annular gas-puff with a center jet driven by Cornell University's COBRA generator operating with a 1 MA, 200 ns current pulse. Using 532 nm laser interferometry and 100 MHz multi-frame cameras, a shock structure is observed to form early in the implosion. The shock appears to be created by a current layer at the outer radius of the imploding plasma which acts as a piston moving inward at several hundred km s−1. The dynamics of the shock and its radial position ahead of the piston agree well with a simple uniform density model outlined in the study by Potter [Nucl. Fusion 18(6), 813 (1978)]. The outer surface of the current layer is observed to be Magneto-Rayleigh-Taylor unstable. The growth rate of this instability is found to depend on the radial density profile of the material within the layer of high-density fluid between the shock and the piston, as predicted by recent theoretical work [see, e.g., D. Livescu, Phys. Fluids 16(1), 118 (2004)]. Growth rates measured in krypton implosions, where the post-shock material is found to decay quasi-exponentially away from the piston, were more than ten times smaller than those recorded in otherwise identical implosions in argon plasmas, where the material between the shock and the piston was observed to maintain a uniform density.

Gas-puff Z-pinch experiments were conducted on the 1 MA, 200 ns pulse duration Cornell Beam Research Accelerator (COBRA) pulsed power generator in order to achieve an understanding of the dynamics and instability development in the imploding and stagnating plasma. The triplenozzle gas-puff valve, pre-ionizer, and load hardware are described. Specific diagnostics for the gas-puff experiments, including a Planar Laser Induced Fluorescence system for measuring the radial neutral density profiles along with a Laser Shearing Interferometer and Laser Wavefront Analyzer for electron density measurements, are also described. The results of a series of experiments using two annular argon (Ar) and/or neon (Ne) gas shells (puff-on-puff) with or without an on-(or near-) axis wire are presented. For all of these experiments, plenum pressures were adjusted to hold the radial mass density profile as similar as possible. Initial implosion stability studies were performed using various combinations of the heavier (Ar) and lighter (Ne) gasses. Implosions with Ne in the outer shell and Ar in the inner were more stable than the opposite arrangement. Current waveforms can be adjusted on COBRA and it was found that the particular shape of the 200 ns current pulse affected on the duration and diameter of the stagnated pinched column and the x-ray yield. V C 2014 AIP Publishing LLC. [http://dx.

Spatially resolved and time-integrated x-ray spectroscopy, combined with modeling of the spectra with detailed radiation kinetics and transport, is a powerful method to study the conditions in a hot moving plasma. K-shell argon spectra were measured from gas puff implosions with different center jet masses on the 1 MA COBRA generator at Cornell University. The outer to inner plenum pressures (1 and 3 psia, respectively) were the same for all shots producing an outer to inner mass ratio of 1:1. This paper uses non-local thermodynamic equilibrium kinetic modeling to infer the ion density, electron temperature, K-shell radiating mass, and K-shell powers from stagnating argon gas puff z-pinch implosion. We find that the implosions with a center jet produced bright spot regions of plasma with higher temperature and density than those without a jet.