The purpose of this research work was to develop and optimize the Solid Lipid Nanoparticles (SLNs) of Tazarotene for the effective topical delivery in the treatment of psoriasis. Tazarotene loaded SLNs were prepared by hot homogenization followed by the ultrasonication using Taguchi’s design and based on the results further investigation was made using central composite design. The lipid Dynasan-116, surfactant poloxomer-188 and co surfactant egg lecithin resulted in better percent drug loading and evaluated for particle size, zeta potential, TEM, drug entrapment efficiency, in vitro drug release and stability. All parameters were found to be in an acceptable range. In vitro drug release of optimized SLN formulation (F1) was found to be 98.12 ± 1.52%, whereas pure drug release was 42.12 after 60 min. The optimized formulation was incorporated into the gel. The release rate (flux) of tazarotene across the membrane and excised skin differs significantly. The accumulative amount of Tazarotene in skin from SLN based gel formulation and marketed gel were 41.12 ± 0.12 mg and 30.02 ± 0.04 mg respectively. This result supported our hypothesis made in skin permeation studies on rat skin. From histopathological studies the microscopic observations indicate that the optimized SLN formulation, SLN based gel formulation and marketed gel has no significant effect on the microscopic structure of the skin. The skin-irritation studies indicated that SLN based gel containing Tazarotene did not show any sign of skin irritation as compared to moderate erythema shown by marketed gel formulation (Tazret® gel) after 72 h of application. Thus, SLN based gel formulation demonstrated advantage over marketed formulation in improving the skin tolerability of Tazarotene indicating their potential in improving patient acceptance and topical delivery of Tazarotene.
The main objective for this investigation is to develop and optimize the solid lipid nanoparticles formulation of acitretin for the effective drug delivery. Acitretin loaded SLNs were prepared by hot homogenization followed by the ultrasonication using Taguchi’s orthogonal array with eight parameters that could affect the particle size and entrapment efficiency. Based on the results from the analyses of the responses obtained from Taguchi design, three different independent variables including surfactant concentration (%), lipid to drug ratio (w/w) and sonication time (s) were selected for further investigation using central composite design. The lipid Dynasan-116, surfactant poloxomer-188 and co surfactant egg lecithin resulted in better percent drug loading and evaluated for particle size, zeta potential, drug entrapment efficiency, in vitro drug release and stability. All parameters were found to be in an acceptable range. TEM analysis has demonstrated the presence of individual nanoparticles in spherical shape and the results were compatible with particle size measurements. In vitro drug release of optimized SLN formulation (F2) was found to be 95.63 ± 1.52%, whereas pure drug release was 30.12 after 60 min and the major mechanism of drug release follows first order kinetics release data for optimized formulation (F2) with non-Fickian (anomalous) with a strong correlation coefficient (R2 = 0.94572) of Korsemeyer-Peppas model. The total drug content of acitretin gel formulation was found to 99.86 ± 0.012% and the diameter of gel formulation was 6.9 ± 0.021 cm and that of marketed gel was found to be 5.7 ± 0.06 cm, indicating better spreadability of SLN based gel formulation. The viscosity of gel formulation at 5 rpm was found to be 6.1 x 103 ± 0.4 x 103 cp. The release rate (flux) of acitretin across the membrane and excised skin differs significantly, which indicates about the barrier properties of skin. The flux value for SLN based gel formulation (182.754 ± 3.126 μg cm−2 h−1) was found to be higher than that for marketed gel (122.345 ± 4.786 μg cm−2 h−1). The higher flux and Kp values of SLN based gel suggest that it might be able to enter the skin easily as compared with marketed gel with an advantage of low interfacial tension of the emulsifier film that ensures an excellent contact to the skin. This topically oriented SLN based gel formulation could be useful in providing site-specific dermal treatment of psoriasis
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.