We describe a comparative study of the oxygen reduction reaction on two carbon-supported Pt-based alloy catalysts in aqueous acidic electrolyte at low temperature. Both alloys have the bulk compositions of 50 and 75 at. % Pt, with the alloying elements being Ni and Co. Comparison is made to a pure Pt catalyst on the same carbon support, Vulcan XC-72, having the same metal loading (20 wt %) and nominally the same particle size (4 ± 2 nm). High-resolution electron microscopy was used to determine the size and shape of the particles as well as the particle size distribution on all catalysts. Electrochemical measurements were performed using the thin-film rotating ring−disk electrode method in 0.1 M HClO4 at 20−60 °C. Hydrogen adsorption pseudocapacitance was used to determine the number of Pt surface atoms and to estimate the surface composition of the alloy catalysts. Kinetic analysis in comparison to pure Pt revealed a small activity enhancement (per Pt surface atom) of ca. 1.5 for the 25 at. % Ni and Co catalysts, and a more significant enhancement of a factor of 2−3 for the 50 at. % Co. The 50 at. % Ni catalyst was less active than the Pt standard and unstable at oxygen electrode potentials. Ring-current collection measurements for peroxide indicated no significant differences between the Pt−Co catalysts or the 25 at. % Ni catalyst and pure Pt, while the 50 at. % Ni catalyst had a higher peroxide yield. Together with the observed Tafel slopes and activation energies, it was concluded that the kinetic enhancement is contained in the preexponential factor of the conventional transition state theory rate expression. It is, however, not clear why the alloying with Ni or Co produces this change in the preexponential factor.

The particle size effect on the formation of OH adlayer, the CO bulk oxidation, and the oxygen reduction reaction (ORR) have been studied on Pt nanoparticles in perchloric acid electrolyte. From measurements of the CO displacement charge at controlled potential, the corresponding surface charge density versus potential curves yielded the potentials of total zero charge (pztc), which shifts approximately 35 mV negative by decreasing the particle size from 30 nm down to 1 nm. As a consequence, the energy of adsorption of OH is more enhanced, that is, at the same potential the surface coverage with OH increases by decreasing the particle size, which in turn affects the catalytic reactions thereon. The impact of the electronically induced potential shift in the OH adsorption is demonstrated at the CO bulk oxidation, in which adsorbed OH is an educt species and promotes the reaction, and the ORR, where it can act as a surface site blocking species and inhibits the reaction.

Cubic Co3O4 nanoparticles with average diameters of 5.9, 21.1, and 46.9 nm (hereafter small, medium, and large) have been synthesized and characterized by pXRD, TEM, and BET. The nanoparticles were loaded onto Ni foam supports for evaluation as anodes for water electrolysis in 1.0 M KOH. Current densities of 10 mA/cm2 were achieved at overpotentials of 328, 363, and 382 mV for anodes loaded with 1 mg/cm2 of small, medium, and large sized Co3O4 nanoparticles, respectively. The activity correlates with the BET surface area of the isolated particles. A plot of the electrochemical overpotential at 10 mA/cm2 against the log of the BET surface area gives a linear relation with a slope of −47 ± 7 mV/dec, showing unequivocally that the activity increase is a function of accessible catalyst surface area.