Experiments have been conducted using laser-driven cylindrical hohlraums whose walls are machined from Ta2O5 foams of 100 mg/cc and 4 g/cc densities. Measurements of the radiation temperature demonstrate that the lower density walls produce higher radiation temperatures than the high density walls. This is the first experimental demonstration of the prediction that this would occur [M. D. Rosen and J. H. Hammer, Phys. Rev. E 72, 056403 (2005)10.1103/PhysRevE.72.056403]. For high density walls, the radiation front propagates subsonically, and part of the absorbed energy is wasted by the flow kinetic energy. For the lower wall density, the front velocity is supersonic and can devote almost all of the absorbed energy to heating the wall.

No abstract

Results of atmospheric propagation for a high-speed, large-actuator-number adaptive optics system are presented. The system uses a microelectromechanical system- (MEMS-) based spatial light modulator correction device with 1024 actuators. Tests over a 1.35-km path achieved correction speeds in excess of 800 Hz and Strehl ratios close to 0.5. The wave-front sensor was based on a quadrature interferometer that directly measures phase. This technique does not require global wave-front reconstruction, making it relatively insensitive to scintillation and phase residues. The results demonstrate the potential of large-actuator-number MEMS-based spatial light modulators to replace conventional deformable mirrors.

A laser-produced plasma has been studied in which there is a peak plasma density between critical and quarter-critical for a substantial amount of time (∼400 psec). The behavior of temporally and spectrally resolved light near the wavelength of the interaction laser λ0, is compared to the decay with time of the peak plasma density inferred from three-halves harmonic emission and Raman scattered light. Evidence for seeding of stimulated Brillouin scattering by the two-plasmon decay instability is presented.

Laboratory breadboard results of a high-speed adaptive-optics system are presented. The wave-front sensor for the adaptive-optics system is based on a quadrature interferometer, which directly measures the turbulence-induced phase aberrations. The spatial light modulator used in the phase-conjugate engine was a microelectromechanical systems-based piston-only correction device with 1024 actuators. Laboratory experiments were conducted with this system utilizing Kolmogorov phase screens to simulate atmospheric phase distortions. The adaptive-optics system achieved correction speeds in excess of 800 Hz and Strehl ratios greater than 0.5 with the Kolmogorov phase screens.