We have performed high-resolution powder x-ray diffraction measurements on a sample of 242 PuCoGa5, the heavy-fermion superconductor with the highest critical temperature Tc = 18.7 K. The results show that the tetragonal symmetry of its crystallographic lattice is preserved down to 2 K. Marginal evidence is obtained for an anomalous behaviour below Tc of the a and c lattice parameters. The observed thermal expansion is isotropic down to 150 K, and becomes anisotropic for lower temperatures. This gives a c/a ratio that decreases with increasing temperature to become almost constant above ∼150 K. The volume thermal expansion coefficient αV has a jump at Tc, a factor ∼20 larger than the change predicted by the Ehrenfest relation for a second order phase transition. The volume expansion deviates from the curve expected for the conventional anharmonic behaviour described by a simple Grüneisen-Einstein model. The observed differences are about ten times larger than the statistical error bars but are too small to be taken as an indication for the proximity of the system to a valence instability that is avoided by the superconducting state.PACS numbers:

Thorium carbide to be tested as target material for the production of 225Ac with the ISOL method, was produced via carbothermal reduction of ThO2 nanoparticles by graphite and graphene oxide, respectively. The use of graphene oxide (GO) as carbon source resulted in a reduced reactivity compared to graphite, confirmed by the presence of unreacted ThO2 mainly in the core of the samples. The reacted ThO2 or ThC2–GO showed a faster reactivity in air, mainly observed as ThC2 amorphization. The specific surface area of the ThC2–GO samples was almost doubled compared to ThC2–graphite samples. The effect of these microstructural features was analysed in terms of thermal diffusivity and calculated thermal conductivity that were both reduced in ThC2–GO samples, however the difference with ThC2–graphite samples decreased at increasing temperature. The present study shows that the use of unreduced GO inhibits the solid-state reaction between ThO2 and C; on the other hand, the high reactivity of the ThC2 so produced is expected to be beneficial for the 225Ac production with the ISOL method, affording a high release efficiency. It is expected that the use of reduced GO could represent a good solution for highly efficient ThC2 targets.

Nuclear powder targets for neutron-induced cross section measurements were prepared by pressing. The choice of the production technique was related to the type of nuclear experiment and the quality of the powder. This paper describes the production process of unsintered compacts of 94Mo, 95Mo, 96Mo metal powders and 239PuO2 powder with a thickness as low as possible by uniaxial pressing of powders. Special attention goes to the difficulties encountered during the preparation process of 239PuO2 pellets. Investigation on the presence of impurities and so the quality of the PuO2 material was performed by scanning electron microscopy with energy dispersive X-ray spectroscopy, by inductively coupled plasma mass spectrometry, X-ray diffraction and by thermal analysis.