The findings of the EU 'Materials Assessment Group' (MAG), within the 2012 EU Fusion Roadmap exercise, are discussed. MAG analysed the technological readiness of structural, plasma facing and high heat flux materials for a DEMO concept to be constructed in the early 2030s, proposing a coherent strategy for R&D up to a DEMO construction decision.A DEMO phase I with a 'Starter Blanket' and 'Starter Divertor' is foreseen: the blanket being capable of withstanding ≥2MW.yr.m -2 fusion neutron fluence (~20 dpa in the frontwall steel). A second phase ensues for DEMO with ≥5MW.yr.m -2 first wall neutron fluence.Technical consequences for the materials required and the development, testing and modelling programmes, are analysed using: a systems engineering approach, considering reactor operational cycles, efficient maintenance and inspection requirements, and interaction § Corresponding author. Address as 1. email: derek.stork@btinternet.com *Manuscript Click here to view linked References with functional materials/coolants; and a project-based risk analysis, with R&D to mitigate risks from material shortcomings including development of specific risk mitigation materials.The DEMO balance of plant constrains the blanket and divertor coolants to remain unchanged between the two phases. The blanket coolant choices (He gas or pressurised water) put technical constraints on the blanket steels, either to have high strength at higher temperatures than current baseline variants (above 650ºC for high thermodynamic efficiency from He-gas coolant), or superior radiation-embrittlement properties at lower temperatures (~290-320ºC), for construction of water-cooled blankets. Risk mitigation proposed would develop these options in parallel, and computational and modelling techniques to shorten the cycle-time of new steel development will be important to achieve tight R&D timescales. The superior power handling of a water-cooled divertor target suggests a substructure temperature operating window (~200-350ºC) that could be realised, as a baseline-concept, using tungsten on a copper-alloy substructure. The difficulty of establishing design codes for brittle tungsten puts great urgency on the development of a range of advanced ductile or strengthened tungsten and copper compounds.Lessons learned from Fission reactor material development have been included, especially in safety and licensing, fabrication/joining techniques and designing for in-vessel inspection. The technical basis of using the ITER licensing experience to refine the issues in nuclear testing of materials is discussed.Testing with 14MeV neutrons is essential to Fusion Materials development, and the Roadmap requires acquisition of ≥30 dpa (steels) 14MeV test data by 2026. The value and limits of pre-screening testing with fission neutrons on isotopically-or chemically-doped steels and with ion-beams are evaluated to help determine the minimum14 MeV testing programme requirements.

No abstract

No abstract

Above-threshold ionization (ATI) electron energy spectra of argon with 800 nm, 40 fs pulses display a contrast which goes through a sharp minimum around 6 × 10 13 W cm −2. The contrast change encompasses the whole ATI spectrum including the two plateaux. The results of a full numerical solution of the time-dependent Schrödinger equation and the integration over the interaction volume show that in the low-energy part of the spectrum this effect is due to the closing of the 12-photon ionization channel and the correlated opening of the possibility for 12-photon resonances with a different parity. However, the calculation suggests a different origin for the substructure observed in the plateau.

International audienceUltrashort self-guided laser pulses are employed to generate high-order harmonics in noble gases. Interference fringes between fundamental and harmonic waves over several cm reveal a long range longitudinal coherence of the generated harmonics. Quasiphase matching is demonstrated for the third harmonic wave

No abstract

No abstract

No abstract