Global warming triggered efforts on sustainable materials in any area of production. Thus, the construction materials were also at the edge of a sharp change to achieve less harm to the environment by reducing the carbon print. Consequently, researchers have been trying to replace the cement from the mixtures of reinforced concrete as cement production causes large amounts of carbon dioxide emissions. Alkali‐activated binders are proved to be versatile alternatives to cementitious binders; however, accurate mathematical models to predict the capacities of these structural elements are limited in number. Therefore, in this study, a new stress–strain model has been developed to estimate the flexural capacity of geopolymer structural elements originated from construction and demolition waste. The study was initiated by formulating a novel stress–strain model applicable for defining the compressive behavior of geopolymer concrete. The formulation was based on recent experimental findings on flexural behavior of geopolymer beam specimens. Then, the performance of the proposed stress–strain model in estimating the ultimate moment capacities was investigated by using 36 bending tests from the literature. The results showed that the proposed model had very little deviations and enhanced accuracy compared with the literature available estimation method recommended by the ACI318. In addition, a soft database composed of 50 different beam specimens with varying mechanical properties and reinforcement patterns was formed. Numerical models corresponding to all possible combinations of each parameter were generated, and their load capacities were determined. After that, the estimation performances of the proposed method and the stress–strain models from the literature, and also the ACI318 procedure were examined. The conclusion of this check also yielded promising results with an absolute mean percentage error of 5.13% regardless of the mode of failures.
The piers can be placed on the spillway crest to hold the sluice gate for controlling the flow or support a service bridge. In addition, these piers to be placed on spillway body provide air entry to prevent negative pressure on the crest and eliminate the risk of cavitation. However, piers and abutments reduce the flow section area and it may cause increasing in reservoir water level. This contraction in the section varies depending on the thickness of the piers besides shape of the cross section. There are some theoretical methods in literature to calculate reduce in effective length of crest. In this study, experimental studies have been done on circular and square section bridge legs in laboratory environment. The results obtained from the studies showed that there are serious differences between experimental and theoretical calculations.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.