The effect of staining solutions on the color of each test material in each session was perceivable by the human eye (DeltaE > 1); however, the color shifts of all test materials were clinically acceptable (DeltaE < 3.7) except for soft liner in nicotine, which was not clinically acceptable over time. Therefore, minimizing drinking of such beverages and use of tobacco, particularly when soft liner is applied, may be advantageous for denture wearers for long-term color stability.

No abstract

The aim of this study was to determine water sorption, solubility and dimensional stability of injection and compression-molded polymethyl methacrylate based denture base polymer that was reinforced with various concentrations and lengths of E-glass fibers. For water sorption and solubility, 20 test groups with different fiber contents and lengths of fibers were prepared. Test specimens without fibers were used as a control. The water sorption and solubility was measured after 90 days water storage. For dimensional stability, rhombic test specimens were prepared and the dimensional changes were measured after processing, drying and storing in water for 4 days and 30 days and were compared with those on the brass model. The water sorption and solubility of injection-molded denture base polymer was lower compared to compression-molded specimens (p < 0.05). The dimensional accuracy of denture base polymer was not affected with fiber reinforcement (p > 0.05).

The purpose of this study was to evaluate the stress distribution in a maxillary central incisor restored with various post-core applications. The study used a three-dimensional finite element method. The tooth was assumed to be endodontically treated with a porcelain crown. Two different sizes of Flexi-post, Cera-post, and Composipost were compared for 200 N palatal and incisal loads. It was determined that, purely from the point of view of strength considerations, core material was determined to be of greater importance than post material or size. Higher elastic moduli of the posts resulted in lower stresses throughout the tooth.

Endocrowns were manufactured using different restorative materials to evaluate the marginal adaptation and fracture strength. Fifty endodontically treated mandibular first molar teeth were divided into five groups (n = 10). Endocrowns were obtained from lithium disilicate glass ceramic ingots by heat‐press technique (Group e.max Press: GEP), and from feldspathic blocks (Group Cerec: GC), polymer infiltrated ceramic network blocks (Group Enamic: GE), lithium disilicate glass ceramic blocks (Group e.max CAD: GEC), and zirconia‐reinforced glass ceramic blocks (Group Suprinity: GS) by CAD/CAM technique. After thermocycling, marginal adaptation was evaluated under scanning electron microscope at ×200 magnification. The specimens' fracture strengths were tested in universal test machine, and fracture types were evaluated. Statistical analyses were performed with Kruskal–Wallis test. The highest marginal gap value was found in GEP, but no significant differences were determined among the other four groups (p > .05). Significant differences were observed among the groups in terms of fracture strength (p = .019). The fracture strength values of GEC were significantly higher than GE, GC, and GS (p < .05). Values were not significantly different between the GEC and GEP groups (p > .05). CAD/CAM endocrowns showed better marginal adaptation than heat‐pressed endocrowns. Clinically acceptable marginal gaps were seen in both endocrown types. Both CAD/CAM and heat‐pressed lithium disilicate glass ceramic endocrowns showed higher fracture strength.