Produksi air lindi akibat tumpukan sampah akan mencemari lingkungan dan air tanah di bawahnya apabila tidak diolah dengan baik. Air lindi memiliki banyak padatan tersuspensi sehingga memerlukan koagulan sebagai pengikat antar partikel padatan. Penelitian ini merancang unit sedimentasi primer dengan mempertimbangkan kecepatan pengendapan ketika diberi koagulan. Berdasarkan hasil pengujian jar test diperoleh dosis optimum PAC 2500 mg/L karena memiliki nilai turbiditas dan COD terkecil berturut-turut sebesar 0.46 NTU dan 163 mg/L. Dosis koagulan terpilih selanjutnya dilakukan pengukuran hindered settling sehingga menghasilkan nilai ketinggian kritis 15,9 cm dan waktu kritis 76,7 menit. Proses pengendapan zona kompresi terjadi pada menit ke-183 ditandai dengan melandainya kurva. Desain unit sedimentasi primer berdasarkan karakteristik kecepatan pengendapan pada air lindi dapat mengadopsi persamaann Vesilind dan Yoshida-Dick. Nilai koefisien pengendapan dengan persamaan Vesilind dan Yoshida-Dick masing-masing sebesar 2 × 10-6 m3/gr dan 9,82 × 10-3 m3/gr. Persamaan Vesilind menghasilkan nilai kecepatan pengendapan sebesar 0,009 cm/detik, sedangkan persamaan Yoshida dan Dick sebesar 0,01 cm/detik. Berdasarkan kurva hindered diperoleh nilai Hu sebesar 5,23 cm dan Tu sebesar 183,74 menit. Nilai Hu dan Tu dapat memperoleh nilai SOR sebesar 2,39 m3/m2. Debit aliran ditentukan sebesar 100 L/detik maka diperoleh nilai luas area permukaan sedimentasi sebesar 3614,74 m2 dan diameter unit sedimentasi diperoleh sebesar 66,67 m. Kedalaman total dan diameter unit sedimentasi primer diperoleh sebesar 4,59 m dan 66,67 m. Desain struktur unit sedimentasi terdiri atas struktur influen, orifice submerge EDI, dan struktur efluen agar debit influen yang memasuki unit sedimentasi tidak mengganggu proses pengendapan. Hubungan antara nilai pemodelan kecepatan pengendapan dengan desain unit sedimentasi diharapkan mampu mengoptimumkan proses pengendapan pada air lindi dengan menggunakan koagulan PAC.
Beban limbah cair industri kertas meningkat seiring dengan peningkatan produksi kertas di Indonesia. Konsentrasi COD berkisar antara 8.300–45.384 mg/L O2 dan TSS sebesar 41.000 mg/L. Salah satu upaya untuk mengurangi beban COD dan TSS di dalam limbah cair industri kertas adalah dengan memanfaatkan proses lumpur aktif. Penelitian ini difokuskan pada pengaruh proses sedimentasi di dalam unit lumpur aktif untuk mereduksi COD dan TSS. Penelitian ini juga mencakup analisis dua tipe pengendapan, yaitu pengendapan partikel diskrit dan pengendapan flok. Tujuan utama penelitian ini untuk mengestimasi nilai hydraulic loading rate dan solid loading rate serta rekomendasi dimensi unit sedimentasi lumpur aktif. Penelitian ini meliputi kegiatan monitoring kinerja proses dengan tiga variasi waktu detensi (HRT). Beberapa variabel yang diperhatikan untuk mencapai tujuan penelitian ini, antara lain kecepatan pengendapan bebas (v), percepatan gravitasi (g), massa jenis partikel (ρs), massa jenis fluida (ρ), diameter partikel (d), dan koefisien penarikan atau drag coefficient (Cd). Pengukuran reduksi COD mengacu pada SNI 6989.2:2009 dan pengukuran reduksi TS mengacu pada SNI 06-6989.26-2005. Penelitian ini menunjukkan bahwa kecepatan pengendapan discrete particle settling tergantung pada karakteristik satuan partikel berdasarkan diameter partikel. Kecepatan pengendapan flocculant settling tergantung pada pengaruh interaksi partikel dalam pembentukan flok atau gumpalan beberapa entitas partikel. Jika ditinjau dari nilai umur lumpur (SLR), HRT 8 jam dan HRT 12 jam menunjukkan kondisi under loaded pada unit sedimentasi. Sementara itu, nilai HLR dan SLR pada HRT 6 jam telah memenuhi rentang kriteria desain lumpur aktif. Dengan demikian, desain terbaik untuk unit sedimentasi sekunder lumpur aktif, yaitu HRT 6 jam dengan HLR sebesar 42,16 m3/m2hari, SLR sebesar 102,45 kg/m2hari dan rata-rata reduksi padatan total mencapai 89,26%.ABSTRACTThe influence of paper production affect simultenously to the increase of pulp and paper wastewater in Indonesia. The COD concentration ranged from 8,300–45,384 mg/L O2 and TSS was 41,000 mg/L. Reducing COD and TSS concentrations in the paper industry wastewater is to utilize by using activated sludge processes. This research was focused on the effect of sedimentation process in activated sludge to reduce COD and TSS. This research also included the analysis of two types of deposition, namely discrete particle settling and floc settling. Main objective this research was directed at determining the value of the hydraulic loading rate and solid loading rate as well as recommendations for the dimensions of the activated sludge sedimentation unit. This research included monitoring of process performance with three variations of detention time (HRT). There were several variables that are considered to achieve the objectives of this study, including free deposition velocity (v), acceleration due to gravity (g), particle density (ρs), fluid density (ρ), particle diameter (d), and drag coefficient. coefficient (Cd). The COD and TS reduction measurement refered to SNI 6989.2:2009 and SNI 06-6989.26-2005, respectively. This study showed that the speed of discrete particle settling depends on the characteristics of the particle unit as seen from the particle diameter. The deposition rate of flocculant settling depends on the effect of particle interactions in the formation of flocs or agglomerates of several particle entities. When viewed from the SLR value obtained, the 8-hour HRT and 12-hour HRT indicated that the sedimentation unit was in an under-loaded condition. Meanwhile, the HLR and SLR values at HRT 6 hours complied the activated sludge design criteria. Thus, the best design for the activated sludge secondary sedimentation unit was HRT 6 hours with an HLR of 42,16 m3/m2day, an SLR of 102,45 kg/m2day and an average total solids reduction of 89,26%.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.