Energy and exergy efficiency amelioration of the parabolic trough has taken high interest since recent years, especially when nanofluid used as an enhancement category. This paper aimed to improve LS-2 parabolic trough model and compare the enhancement effect that occurred using different mono and hybrid nanofluids. Inserting mono nanoparticles of Al 2 O 3 , CeO 2 , CuO, and hybrid combinations of Al 2 O 3 with CeO 2 , or CuO nanoparticles in a Syltherm 800 was investigated by five different cases. The investigation was presented under total volume fraction 4% for all nanofluids and mixing fraction 50:50 for the hybrid types in order to facilitate the analysis and compare various results at the same conditions. Those cases and their comparisons were solved using MATLAB Symbolic tools under turbulent flow regime and variable inlet temperature to present wide domain behavior for the energy and exergy efficiency, Nusselt number, heat transfer coefficient, and pressure drop, whereas the analytical solution of the energy balance equation was taken from the literature and improved to cover the mentioned cases. Moreover, the results were compared with previous researches that used different thermal fluid and showed high accuracy behavior with low deviation. Therefore, the findings showed that Al 2 O 3 and CeO 2 hybrid nanofluids were more efficient than using of both Al 2 O 3 and CuO hybrid nanofluids and any mono nanofluids contain the same nanoparticles. The maximum enhancement of thermal and exergy efficiency of using Al 2 O 3 and CeO 2 hybrid nanofluids was 1.09% and 1.03%, respectively, whereas it was enhanced by 167.8% and 200.7% for the Nusselt number and heat transfer coefficient, respectively. Also, the hybrid nanofluids have higher advantage over the mono nanofluids by presenting lower pressure drop values. Finally, the assessment of efficiency variation affected by thermal properties of the nanoparticle was presented under optimum temperature equal to 575 K.
In many heat exchange systems, there is a demand to improve the thermal conductivity of the working fluids to make those fluids more efficient, and this can be done by dispersing solid nanomaterials into conventional liquids. In the present work, the thermal conductivity of alumina, ceria, and their hybrid with ratio (50:50) by volume-based deionized water nanofluids was experimentally measured. The nanofluids were prepared by two-step method with a range of dilute volume concentration (0.01-0.5 % Vol.), and measured at various temperatures (35, 40, 45, and 50 ºC). The experimental data for basefluid and nanofluids were verified with theoretical and experimental models, and the results have shown good agreement within the accuracy of the thermal conductivity tester. The results demonstrated that the higher thermal conductivity enhancement percentages for Al2O3, CeO2, and their hybrid nanofluids were (5.3 %, 3.3 %, and 8.8 %) at volume concentration (0.5 % Vol.) and temperature (50 ºC) compared to deionized water, respectively. Moreover, a correlation was proposed for the thermal conductivity enhancement ratio of the hybrid nanofluid and showed good accuracy with measured experimental data.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.