Super-hydrophobic surfaces may arise due to an interplay between the intrinsic, relatively high, contact angle of the more or less hydrophobic solid surface employed and the geometric features of the solid surface. In the present work, this relationship was investigated for a range of different surface geometries, making use of surface free energy minimization. As a rule, the free energy minima (and maxima) occur when the Laplace and Young conditions are simultaneously fulfilled. Special effort has been devoted to investigating the free energy barriers present between the Cassie-Baxter (heterogeneous wetting) and Wenzel (homogeneous wetting) modes. The predictions made on the basis of the model calculations compare favorably with experimental results presented in the literature.
Paper samples were rendered superhydrophobic with Alkyl Ketene Dimer using (1) Airblasting with cryo ground micro particles, (2) crystallizing from organic solvents and (3) spraying with Rapid Expansion of Supercritical Solutions (RESS) technique. The papers were characterized using Scanning Electron Microscopy, contact angle to water measurements and X-ray Photoelectron Spectroscopy (XPS). Advancing contact angles were in the region of 150°-160°and receding contact angles were in the region of 110°-130°. Diagrams showing the drop base diameter vs. the contact angle when water is pumped into, and then withdrawn from, a sessile drop show that a stick slip pattern is present in the advancing phase for a non coated internally sized paper. Papers rendered superhydrophobic with the RESS technique showed a much less pronounced stick slip pattern in the advancing phase but still a stick slip pattern in the receding phase.
Articles you may be interested inGrowth of fullerene-like carbon nitride thin solid films by reactive magnetron sputtering; role of low-energy ion irradiation in determining microstructure and mechanical properties J. Appl. Phys. 93, 3002 (2003); 10.1063/1.1538316 Elastic modulus of amorphous boron suboxide thin films studied by theoretical and experimental methods J. Appl. Phys. 93, 940 (2003); 10.1063/1.1531811 Formation of hydrogenated carbon nitride films by reactive sputtering
Synthesis and mechanical properties of boron suboxide thin filmsBoron suboxide thin films, with controlled carbon content, were grown by rf dual magnetron sputtering of boron and carbon targets in an argon-oxygen atmosphere. Film composition, structure, mechanical, and electrical properties were evaluated with x-ray photoelectron spectroscopy, Auger electron spectroscopy, x-ray diffraction, transmission electron microscopy, nanoindentation, and high-frequency capacitance-voltage measurements. X-ray amorphous B-O-C films (O/Bϭ0.02) showed an increase in density from 2.0 to 2.4 g/cm 3 as C content was increased from 0 to 0.6 at. % and the film with the highest density had nanocrystalline inclusions. The density increase occurred most likely due to the formation of B-C bonds, which are shorter than B-B bonds. All measured material properties were found to depend strongly on the C content and thus film density. The elastic modulus increased from 188 to 281 GPa with the increasing C content, while the relative dielectric constant decreased from 19.2 to 0.9. Hence, B-O-C films show a potential for protective coatings and even for application in electronic and optical devices.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.