Depreme dayanıklı yapı tasarımında kat adedi arttıkça, taşıma kapasitesini aşmamak, yatay ötelenmeleri sınırlamak ve çerçeve içi bölme duvarların hasar görmesini engellemek için betonarme perde elemanların kullanımı zorunlu hale gelmektedir. Depreme maruz kalmış yapılar incelendiğinde, bazı binalarda yeteri kadar betonarme perde eleman bulunmamasından dolayı, yatay ötelenmelerin sınır değerleri aştığı, perde elemanların daha büyük kesme gerilmelerine maruz kaldığı ve beklenmedik öncül gevrek kesme göçmelerinin perdelerde ortaya çıktığı görülmektedir. Betonarme çerçeve sisteme kısmi perde elemanların eklenmesiyle çerçeve sistem davranışının karma sistem davranışına evirildiği, perde oranının daha da arttırılmasıyla, konsol kirişe benzetilen perde duvar davranışına geçtiği bilinmektedir. Yatay deplasmanları sınırlamak için sadece tek bir kat alanına bağlı olarak gerekli perde duvar alanının belirlenmesi üzerine birçok çalışma bulunmaktadır. Burada ise binanın perde duvar davranışı göstermesi için kolon ve perdelerin ön tasarımı aşamasında, donatı artış oranına bağlı olarak bina maliyetindeki artış ve perde-çerçeve davranış uyumluluğu dikkate alınarak, perdelerin karşıladığı momentin bina taban momentine oranına bağlı, bir kattaki perde alanının tüm katların alanına oranının minimum değeri tespit edilmeye çalışılmıştır. Bu amaçla, Türkiye Bina Deprem Yönetmelik (TBDY-2018) kurallarına uygun çerçeve sistemden oluşan beş katlı ve planda simetrik bir bina tasarlanmıştır. Öncelikle, kiriş-kolon çerçeve sistemden oluşan bu modele asansör perdesi eklenmiş, daha sonra asansörlü modele çeşitli oranlarda simetrik perdeler ilave edilerek toplamda 10 model oluşturulmuştur.Anahtar Kelimeler: Betonarme binalarda depreme dayanıklı yapı tasarımı, perde-çerçeve taşıyıcı sistemlerde minimum perde oranı, perde momentinin taban momentine oranı, etkin göreli kat ötelemesi, gevrek kesme göçmesi.
96% of the available buildings in use in Turkey are taking place in the earthquake zone and approximately 50% of them an masonry structures built using bricks. Sliding shear strength and internal friction coefficient were taken as a constant value in Turkish Earthquake Code (TSC 2007) depending on the type and hole rate of the brick section regardless of available compressive strength of the brick, mortar and plaster of a wall. But nowadays these values are recommended to be taken according to the compressive strength of mortar in TSC-2018. In addition, with this study it is recommended that, to evaluate the performance of a building against earthquake, the mechanical properties of the materials used for a building must be determined on site with series of tests. It is well-known that for each building mechanical properties of mortar and plaster are variable because of site work conditions.In this study, a couple of tests were conducted in different storeys of a five-storey-masonry building representing the clay brick masonry buildings in the country built in the 1950s, to determine the sliding shear strength and internal friction coefficient, using a similar method to shove test. With the increment of axially vertical load from upper storey to lower storey, the shear capacity in the lower storeys of the buidling are much lower than the respective values in upper storeys. In order to determine a characteristic shear force for the building, it has been revised considering the lowest compressive strength of mortar in the storeys. Related with the internal friction coefficient obtained, a quite good correlation was found between the results and the standards. However, the sliding shear strength was found to be approximately three times higher than TSC 2007 and about two times higher than TSC 2018. This means that, the limits recommended in the standards are much safer than results obtained from the tests.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.