We analyze and optimize a wireless system with energy transfer in the downlink and information transfer in the uplink, under quasi-static Nakagami-m fading. We consider ultra-reliable communication scenarios representative of the fifth-generation of wireless systems, with strict error and latency requirements. The error probability and delay are investigated, and an approximation for the former is given and validated through simulations. The numerical results demonstrate that there are optimum numbers of channels uses for both energy and information transfer for a given message length. Index TermsUltra-Reliable communications, short packets, energy transfer, quasi-static Nakagami-m fading.

While 5G is being rolled out in different parts of the globe, few research groups around the world − such as the Finnish 6G Flagship program − have already started posing the question: What will 6G be? The 6G vision is a data-driven society, enabled by near instant unlimited wireless connectivity. Driven by impetus to provide vertical-specific wireless network solutions, machine type communication encompassing both its mission critical and massive connectivity aspects is foreseen to be an important cornerstone of 6G development. This article presents an over-arching vision for machine type communication in 6G. In this regard, some relevant performance indicators are first anticipated, followed by a presentation of six key enabling technologies.

Recent advances on wireless energy transfer (WET) make it a promising solution for powering future Internet-of-Things (IoT) devices enabled by the upcoming sixth-generation (6G) era. The main architectures, challenges and techniques for efficient and scalable wireless powering are overviewed in this article. Candidates enablers, such as energy beamforming (EB), distributed antenna systems (DASs), advances on devices' hardware and programmable medium, new spectrum opportunities, resource scheduling, and distributed ledger technology are outlined. Special emphasis is placed on discussing the suitability of channel state information (CSI)-limited/free strategies when powering simultaneously a massive number of devices. The benefits from combining DAS and EB, and from using average CSI whenever available, are numerically illustrated. The pros and cons of the state-of-the-art CSI-free WET techniques in ultralow power setups are thoroughly revised, and some possible future enhancements are outlined. Finally, key research directions toward realizing WET-enabled massive IoT networks in the 6G era are identified and discussed in detail. Index Terms-Channel state information (CSI), distributed antenna systems (DASs), distributed ledger technology (DLT), energy beamforming (EB), intelligent reflective surfaces, Internet of Things (IoT), massive wireless energy transfer (WET), millimeter wave, sixth generation (6G), ultralow power. I. INTRODUCTION T HE SIXTH generation (6G) of wireless systems targets a data-driven sustainable society, enabled by nearinstant, secure, unlimited and green connectivity [1]-[3]. Stringent performance requirements in terms of security and

Wireless Energy Transfer (WET) is emerging as a potential solution for powering small energy-efficient devices. We propose strategies that use multiple antennas at a power station, which wirelessly charges a large set of single-antenna devices. Proposed strategies operate without Channel State Information (CSI) and we attain the distribution and main statistics of the harvested energy under Rician fading channels with sensitivity and saturation energy harvesting (EH) impairments. A switching antenna strategy, where a single antenna with full power transmits at a time, provides the most predictable energy source, and it is particularly suitable for powering sensor nodes with highly sensitive EH hardware operating under non-LOS (NLOS) conditions; while other WET schemes perform alike or better in terms of the average harvested energy. Under NLOS switching antennas is the best, while when LOS increases transmitting simultaneously with equal power in all antennas is the most beneficial. Moreover, spatial correlation is not beneficial unless the power station transmits simultaneously through all antennas, raising a trade-off between average and variance of the harvested energy since both metrics increase with the spatial correlation. Moreover, the performance gap between CSI-free and CSI-based strategies decreases quickly as the number of devices increases.

No abstract

No abstract

No abstract

Wireless energy transfer (WET) is a green enabler of low-power Internet of Things (IoT). Therein, traditional optimization schemes relying on full channel state information (CSI) are often too costly to implement due to excessive energy consumption and high processing complexity. This letter proposes a simple, yet effective, energy beamforming scheme that allows a multi-antenna power beacon (PB) to fairly power a set of IoT devices by only relying on the first-order statistics of the channels. In addition to low complexity, the proposed scheme performs favorably as compared to benchmarking schemes and its performance improves as the number of PB's antennas increases. Finally, it is shown that further performance improvement can be achieved through proper angular rotations of the PB.