Fabricating nanofibres with reproducible characteristics is an important demand in the membrane industry in order to establish commercial viability. In this study, the effect of controlled atmospheric conditions on electrospun cellulose acetate (CA) nanofibres was evaluated for temperatures ranging 17.5-32.5°C and relative humidity ranging 20-70%. CA solution (0.2 g/mL) in a solvent mixture of acetone/dimethylformamide/ethanol (2:2:1) was electrospun into nonwoven fibre mesh with the fibre diameter ranging from 150 nm to 1 lm. The resulting nanofibres were analysed by differential scanning calorimetry, showing a correlation of reducing melt enthalpy with increasing atmospheric temperature. The opposite was seen with increasing atmospheric humidity, which conferred increasing melt enthalpy. Analysis of scanning electron microscopy images provided a correlation of reducing average fibre diameter with increasing atmospheric temperature and increasing fibre diameter with increasing atmospheric humidity. These results correlate with the melt enthalpy results, suggesting that finer CA nanofibres infer a lower melt enthalpy. Together these studies provide strong evidence that the controlled atmospheric conditions affect the fibre diameter of the resulting electrospun nanofibres. A salient observation in this study was that increased humidity reduced the effect of fibre beading yielding a more consistent and therefore better quality of fibre. This has apparent implications for the reproducibility of nanofibre production and offers a new method of controlling fibre morphology. This study has highlighted the requirement to control atmospheric conditions during the electrospinning process to fabricate reproducible fibre mats.

Electrospun polymeric nanofiber adsorbents offer an alternative ligand support surface for bioseparations. Their non-woven fiber structure with diameters in the sub-micron range creates a remarkably high surface area. To improve the purification productivity of biological molecules by chromatography, cellulose nanofiber adsorbents were fabricated and assembled into a cartridge and filter holder format with a volume of 0.15 mL, a bed height of 0.3 mm and diameter of 25 mm. The present study investigated the performance of diethylaminoethyl (DEAE) derivatized regenerated cellulose nanofiber adsorbents based on criteria including mass transfer and flow properties, binding capacity, and fouling effects. Our results show that nanofibers offer higher flow and mass transfer properties. The non-optimized DEAE-nanofiber adsorbents indicate a binding capacity of 10% that of packed bed systems with BSA as a single component system. However, they operate reproducibly at flowrates of a hundred times that of packed beds, resulting in a potential productivity increase of 10-fold. Lifetime studies showed that this novel adsorbent material operated reproducibly with complex feed material (centrifuged and 0.45 µm filtered yeast homogenate) and harsh cleaning-in-place conditions over multiple cycles. DEAE nanofibers showed superior operating performance in permeability and fouling over conventional adsorbents indicating their potential for bioseparation applications.