No abstract

No abstract

Saccharomyces cerevisiae yeast cells encapsulated with pH-responsive synthetic nanoshells from lightly cross-linked polymethacrylic acid showed a high viability rate of around 90%, an indication of high biocompatibility of synthetic pH-responsive shells. We demonstrated that increasing pH above the isoelectric point of the polymer shell leads to a delay in growth rate; however, it does not affect the expression of enhanced green fluorescent protein. We suggest that progressive ionization and charge accumulation within the synthetic shells evoke a structural change in the outer shells which affect the membrane transport. This change facilitates the ability to manipulate growth kinetics and functionality of the cells with the surrounding environment. We observed that hollow layer-by layer nanoshells showed a remarkable degree of reversible swelling/deswelling over a narrow pH range (pH 5.0-6.0), but their assembly directly on the cell surface resulted in the suppression of large dimensional changes. We suggest that the variation in surface charges caused by deprotonation/protonation of carboxylic groups in the nanoshells controlled cell growth and cell function, which can be utilized for external chemical control of cell-based biosensors.

We demonstrate the assembly of extremely robust and pH-responsive thin shell LbL microcapsules from silk fibroin counterparts modified with poly(lysine) and poly(glutamic) acid which are based on biocompatible silk ionomer materials in contrast to usually exploited synthetic polyelectrolytes. The microcapsules are extremely stable in the unusually wide pH range from 1.5 to 12.0 and show remarkable degree of reversible swelling/deswelling response in dimensions as exposed to extreme acidic and basic conditions. These changes are accompanied by reversible changes in shell permeability which can be utilized for pH-controlled loading and unloading of large macromolecules. Finally, we confirmed that these shells can be utilized to encapsulate yeast cells with viability rate much higher than that for traditional synthetic polyelectrolytes.

The mechanical properties of hydrogen-bonded layer-by-layer (LbL) microcapsule shells constructed from tannic acid (TA) and poly(vinylpyrrolidone) (PVPON) components have been studied in both the dry and swollen states. In the dry state, the value of the elastic modulus was measured to be within 0.6-0.7 GPa, which is lower than the typical elastic modulus for electrostatically assembled LbL shells. Threefold swelling of the LbL shells in water results in a significant reduction of the elastic modulus to values well below 1 MPa, which is typical value seen for highly compliant gel materials. The increase of the molecular weight of the PVPON component from 55 to 1300 kDa promotes chain entanglements and causes a stiffening of the LbL shells with a more than 2-fold increase in elastic modulus value. Moreover, adding a polyethylenimine prime layer to the LbL shell affects the growth of hydrogen-bonded multilayers which consequently results in dramatically stiffer, thicker, and rougher LbL shells with the elastic modulus increasing by more than an order of magnitude, up to 4.3 MPa. An alternation of the elastic properties of very compliant hydrogen-bonded shells by variation of molecular weight is a characteristic feature of weakly bonded LbL shells. Such an ability to alter the elastic modulus in a wide range is critically important for the design of highly compliant microcapsules with tunable mechanical stability, loading ability, and permeability.