Abstract-At present Nb 3 Sn Rutherford Cables seem to be the most suitable conductors for next generation superconducting accelerator magnets. These magnets will have a peak field in the coils larger than 10 T and the large Lorentz forces will impose coil pre-stresses significantly larger than 100 MPa. Since Nb 3 Sn is strongly sensitive to strain it is mandatory to characterize the cable under a transverse pressure comparable to the one experienced in future magnets. As a part of its High Field Magnet program, CERN is developing a sample holder for the FRESCA Facility that allows testing 10 mm wide superconducting Rutherford cables under a transverse pressure up to 200 MPa. The sample holder will be able to house cables up to 20 mm wide. In this paper the conceptual design is presented together with the experimental results of the mechanical test performed on a 40 cm long model. The results show that the structure can apply a transverse pressure larger than 200 MPa on 10 mm wide cables with sufficiently high pressure homogeneity.
Linac4, a 160 MeV normal-conducting H-linear accelerator, is the first step in the upgrade of the beam intensity available from the LHC proton injectors at CERN. The Linac4 Low Energy Beam Transport (LEBT) line from the pulsed 2 MHz RF driven ion source, to the 352 MHz RFQ has been built and installed at a test stand, and has been used to transport and match to the RFQ a pulsed 14 mA H-beam at 45 keV. A temporary slit-and-grid emittance measurement system has been put in place to characterize the beam delivered to the RFQ. In this paper a description of the LEBT and its beam diagnostics is given, and the results of beam emittance measurements and beam transmission measurements through the RFQ are compared with the expectation from simulations. Linac4, a 160 MeV normal-conducting H -linear accelerator, is the first step in the upgrade of the beam intensity available from the LHC proton injectors at CERN. The Linac4 Low Energy Beam Transport (LEBT) line from the pulsed 2 MHz RF driven ion source, to the 352 MHz RFQ has been built and installed at a test stand, and has been used to transport and match to the RFQ a pulsed 14 mA H -beam at 45 keV. A temporary slit-and-grid emittance measurement system has been put in place to characterize the beam delivered to the RFQ. In this paper a description of the LEBT and its beam diagnostics is given, and the results of beam emittance measurements and beam transmission measurements through the RFQ are compared with the expectation from simulations.
Abstract-Linac4 is the first element of the LHC Injectors Upgrade Project and will replace the existing Linac2 as linear injector of protons for the CERN accelerators. A new transfer line will link Linac4 to the Proton Synchrotron Booster (PSB). Approximately hundred normal-conducting electro-magnets are required for beam steering and focusing along the linac and the transfer line. This text concentrates on the design of the Linac4 quadrupole magnets. The design and the first magnetic measurements of the inter-tank quadrupole electro-magnets are discussed. In addition, the design and optimization of the transfer line quadrupole magnets are highlighted. The compatibility of the magnetic requirements and the power converter constraints for the latter magnet type is assessed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.