This paper clarified the microstructural element distribution and electrical conductivity changes of kaolin, fly ash, and slag geopolymer at 900 °C. The surface microstructure analysis showed the development in surface densification within the geopolymer when in contact with sintering temperature. It was found that the electrical conductivity was majorly influenced by the existence of the crystalline phase within the geopolymer sample. The highest electrical conductivity (8.3 × 10−4 Ωm−1) was delivered by slag geopolymer due to the crystalline mineral of gehlenite (3Ca2Al2SiO7). Using synchrotron radiation X-ray fluorescence, the high concentration Ca boundaries revealed the appearance of gehlenite crystallisation, which was believed to contribute to development of denser microstructure and electrical conductivity.
Currently, lead-free composite solder technology system is the new approach that have been considered as a promising replacement for toxic SnPb solder alloy. Sn-0.7Cu was used as matrix solder alloy while fly ash geopolymer and kaolin geopolymer with different compositions (0.5 wt.%, 1.0 wt.%, and 1.5 wt.%) was added as a reinforcement to increase the properties of solder alloy. The solder composite was prepared by using powder metallurgy method which consist of mixing, compaction, and sintering process via microwave oven. Microwave sintering approach results in more uniform heating, lower pore coarsening with cost-effective and energy efficiency. The chemical composition and morphology of geopolymer reinforcement was analysed by using X-ray Flourescene and Scanning Electron Microscope. The influences of the geopolymer particulates in the monolithic matrix solder on the interfacial intermetallic compound thickness and wettability were investigated by using optical microscope, while the specific value was measured by using J-image software. The melting point temperature were investigated by using differential scanning calorimeter (DSC). The influences of adding types of geopolymer particulates into Sn-0.7Cu lead free solder were investigated in terms of interfacial intermetallic compounds (IMCs) and thermal properties. It is noted that several addition of fly ash geopolymer and kaolin geopolymer particles can remarkably supressed the thickness of intermetallic layer between composite solder and the substrate and thus gives higher melting temperature but somehow certain composition resulted low in mechanical properties. Overall, the addition of 0.5 wt.% of kaolin geopolymer reinforcements into Sn-0.7Cu lead-free improved all the listed properties of the solder materials.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.