Objective: To test the shear bond strength, surface characteristics, and fracture mode of brackets that are bonded to enamel etched with an erbium, chromium:yttrium-scandium-gallium-garnet (Er,Cr:YSGG) laser operated at different power outputs: 0.5 W, 1 W, and 2 W. Materials and Methods: Human premolars that had been extracted for orthodontic purposes were used. Enamel was etched with an Er,Cr:YSGG laser system operated at one of three power outputs or with orthophosphoric acid. Results: The shear bond strength associated with the 0.5-W laser irradiation was significantly less than the strengths obtained with the other irradiations. Both the 1-W and 2-W laser irradiations were capable of etching enamel in the same manner. This finding was confirmed by scanning electron microscopy examination. The evaluation of adhesive-remnant-index scores demonstrated no statistically significant difference in bond failure site among the groups, except for the 0.5-W laser-etched group. Generally, more adhesive was left on the enamel surface with laser irradiation than with acid etching.
Conclusion:The mean shear bond strength and enamel surface etching obtained with an Er,Cr: YSGG laser (operated at 1 W or 2 W for 15 seconds) is comparable to that obtained with acid etching.
The purpose of this study was to investigate the efficiency of hand instrumentation and laser irradiation on calculus removal from the root surfaces, in vitro. Thirty-two human teeth, extracted for periodontal reasons, were used in this study. Root surfaces of single-rooted teeth were treated by different methods including (1) conventional hand instruments; (2) hand instruments and tetracycline-hydrochloride (Tet-HCl); (3) erbium, chromium:yttrium-scandium-gallium-garnet (Er,Cr:YSGG) laser irradiation, setting I (short pulse); (4) Er,Cr:YSGG laser irradiation, setting II (long pulse). Three premolar teeth, extracted for orthodontic reasons, served as control. The morphology of the root surfaces was evaluated by light and scanning electron microscopy. Energy dispersive X-ray (EDX) analysis was performed to compare the mineral content of root surfaces treated with hand instrumentation and lasing procedures. The results of this study demonstrated that all treatments were efficient in calculus removal from the root surfaces. Thermal changes, including melting and carbonization, were not observed in either lasing procedure. The surface was rougher in the laser groups than in the groups treated with hand instruments. Moreover, roughness was greater in the long-pulse laser setting than in the short-pulse setting. While increased calcium (Ca) and decreased phosphate (P) (weight concentration percent) were observed in all treatments when compared with the control, laser procedures resulted in a more similar mineral content than in the groups treated with hand instruments. Based on these findings, laser procedures, when used in appropriate settings, are capable of performing scaling and root planing in the treatment of periodontitis. It may be concluded that short pulse laser may be more suitable for the micro-morphology of the root surface. However, additional in vitro and clinical studies are necessary to clarify the success of laser in periodontal therapy.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.