No abstract

A characterization study on oil palm decanter cakes (OPDC) was performed to gain an in-depth understanding of the material's characteristics to aid in potential residual oil recovery. The OPDC was characterized by a high moisture content, high biodegradability, high organic content, and a nutrient-rich composition. Microscopic observation showed that the oil attachments in OPDC, and a vast majority of the droplets, were less than 50 μm in size. Furthermore, contact angle measurement revealed the hydrophilic and oleophilic characteristics of OPDC. Specifically, the contact angles of water and crude palm oil (CPO) with OPDC were both less than 45° with absorption rates of 0.0265  0.003 µL/s and 0.1042  0.05 µL/s, respectively. The OPDC is a fibrous material, and the surface area and pore size measured were 7.103 m 2 /g and 481.7 Å, respectively. Fourier transform infrared spectroscopy (FTIR) and thermogravimetric (TG) analysis results showed the functional groups and degradation properties of OPDC, respectively.

The production of palm oil requires a large amount of water, which subsequently turns into wastewater known as palm oil mill effluent (POME). Because of its high organic content, there has been debate over how to utilize POME for oil recovery. POME is usually mainly comprised of water (95 to 96%), total solids (4 to 5%), suspended solids (2 to 4%), and oil (0.6 to 0.7%). The lignocellulosic particles in POME are highly oleophilic and capable of absorbing oil. Therefore, the objective of this study was to understand the presence of residual oil and try to relate with the oil loss in POME and to identify the solid particles in POME and their correlations. Microscopic observations showed that most of the oil droplets available in POME were less than 100 µm in size. If given the opportunity to settle, the highest quantity of oil droplets and solid particles was in the bottom layer, followed by the middle layer, and lastly the upper layer. In cases where the contact angle of water was less than 45° on POME solids, the absorption rate was 0.11 ± 0.03 µL/s and 0.09 ± 0.01 µL/s, respectively. This study concluded that the oil losses in POME were partly due to the absorption of oil by the fibers.