No abstract

Enzymatic haem and non-haem high-valent iron-oxo species are known to activate strong C-H bonds, yet duplicating this reactivity in a synthetic system remains a formidable challenge. Although instability of the terminal iron-oxo moiety is perhaps the foremost obstacle, steric and electronic factors also limit the activity of previously reported mononuclear iron(IV)-oxo compounds. In particular, although nature's non-haem iron(IV)-oxo compounds possess high-spin S = 2 ground states, this electronic configuration has proved difficult to achieve in a molecular species. These challenges may be mitigated within metal-organic frameworks that feature site-isolated iron centres in a constrained, weak-field ligand environment. Here, we show that the metal-organic framework Fe2(dobdc) (dobdc(4-) = 2,5-dioxido-1,4-benzenedicarboxylate) and its magnesium-diluted analogue, Fe0.1Mg1.9(dobdc), are able to activate the C-H bonds of ethane and convert it into ethanol and acetaldehyde using nitrous oxide as the terminal oxidant. Electronic structure calculations indicate that the active oxidant is likely to be a high-spin S = 2 iron(IV)-oxo species.

Metal-organic frameworks (MOFs) constructed from Zr6-based nodes have recently received considerable attention given their exceptional thermal, chemical, and mechanical stability. Because of this, the structural diversity of Zr6-based MOFs has expanded considerably and in turn given rise to difficulty in their precise characterization. In particular it has been difficult to assign where protons (needed for charge balance) reside on some Zr6-based nodes. Elucidating the precise proton topologies in Zr6-based MOFs will have wide ranging implications in defining their chemical reactivity, acid/base characteristics, conductivity, and chemical catalysis. Here we have used a combined quantum mechanical and experimental approach to elucidate the precise proton topology of the Zr6-based framework NU-1000. Our data indicate that a mixed node topology, [Zr6(μ3-O)4(μ3-OH)4(OH)4 (OH2)4](8+), is preferred and simultaneously rule out five alternative node topologies.

The catalytic properties of the metal-organic framework Fe2(dobdc), containing open Fe(II) sites, include hydroxylation of phenol by pure Fe2(dobdc) and hydroxylation of ethane by its magnesium-diluted analogue, Fe0.1Mg1.9(dobdc). In earlier work, the latter reaction was proposed to occur through a redox mechanism involving the generation of an iron(IV)-oxo species, which is an intermediate that is also observed or postulated (depending on the case) in some heme and nonheme enzymes and their model complexes. In the present work, we present a detailed mechanism by which the catalytic material, Fe0.1Mg1.9(dobdc), activates the strong C-H bonds of ethane. Kohn-Sham density functional and multireference wave function calculations have been performed to characterize the electronic structure of key species. We show that the catalytic nonheme-Fe hydroxylation of the strong C-H bond of ethane proceeds by a quintet single-state σ-attack pathway after the formation of highly reactive iron-oxo intermediate. The mechanistic pathway involves three key transition states, with the highest activation barrier for the transfer of oxygen from N2O to the Fe(II) center. The uncatalyzed reaction, where nitrous oxide directly oxidizes ethane to ethanol is found to have an activation barrier of 280 kJ/mol, in contrast to 82 kJ/mol for the slowest step in the iron(IV)-oxo catalytic mechanism. The energetics of the C-H bond activation steps of ethane and methane are also compared. Dehydrogenation and dissociation pathways that can compete with the formation of ethanol were shown to involve higher barriers than the hydroxylation pathway.

Metal-organic frameworks (MOFs) built up from Zr6-based nodes and multi-topic carboxylate linkers have attracted attention due to their favourable thermal and chemical stability. However, the hydrolytic stability of some of these Zr6-based MOFs has recently been questioned. Herein we demonstrate that two Zr6-based frameworks, namely UiO-67 and NU-1000, are stable towards linker hydrolysis in H2O, but collapse during activation from H2O. Importantly, this framework collapse can be overcome by utilizing solvent-exchange to solvents exhibiting lower capillary forces such as acetone.

The mechanism of CO 2 adsorption in the amine-functionalized metal−organic framework mmenMg 2 (dobpdc) (dobpdc 4− = 4,4′-dioxidobiphenyl-3,3′-dicarboxylate; mmen = N,N′-dimethylethylenediamine) was characterized by quantum-chemical calculations. The material was calculated to demonstrate 2:2 amine:CO 2 stoichiometry with a higher capacity and weaker CO 2 binding energy than for the 2:1 stoichiometry observed in most amine-functionalized adsorbents. We explain this behavior in the form of a hydrogen-bonded complex involving two carbamic acid moieties resulting from the adsorption of CO 2 onto the secondary amines.T he predicted growth of the global economy and world population in the near future will lead to an increased demand for energy, 1 resulting in even further increases in the concentration of CO 2 in the atmosphere. The development and worldwide utilization of efficient carbon capture and sequestration (CCS) technologies could reduce the CO 2 emissions associated with the use of fossil fuels. 2 Current carbon capture technologies generally use aqueous solutions of alkanolamines to scrub the flue gases. 3 Amines are known to be very selective toward CO 2 capture from flue gases because of the strong chemical bonds formed in the chemisorption process. To overcome the energy penalty associated with the process, an important new development based on solid materials functionalized with amines has been proposed. 4−10 These materials have much lower heat capacities than aqueous amine solutions. 11 Of particular interest are amines grafted onto the open metal sites of metal−organic frameworks (MOFs). Indeed, recent experiments have shown that in the case of one particular MOF, Mg 2 (dobpdc) (dobpdc 4− = 4,4′-dioxidobiphenyl-3,3′-dicarboxylate), N,N′-dimethylethylenediamine (mmen) can be bound to almost every open metal site lining the one-dimensional channels of the structure ( Figure 1). 4 The high adsorption enthalpy of mmen-Mg 2 (dobpdc) for CO 2 endows the adsorbent with a significant capacity for CO 2 down to very low pressures.The regeneration energy of the solid adsorbent is lower than that of aqueous amine solutions because of its large working capacity and low heat capacity. Understanding reactivity

In the field of metal-metal bonding, the occurrence of stable, multiple bonds between different transition metals is uncommon, and is largely unknown for different first-row metals. Adding to a recently reported iron-chromium complex, three additional M-Cr complexes have been isolated, where the iron site is systematically replaced with other first-row transition metals (Mn, Co, or Ni), while the chromium site is kept invariant. These complexes have been characterized by X-ray crystallography. The Mn-Cr complex has an ultrashort metal-metal bond distance of 1.82 Å, which is consistent with a quintuple bond. The M-Cr bond distances increases across the period from M = Mn to M = Ni, as the formal bond order decreases from 5 to 1. Theoretical calculations reveal that the M-Cr bonds become increasingly polarized across the period. We propose that these trends arise from increasing differences in the energies and/or contraction of the metals' d-orbitals (M vs Cr). The cyclic voltammograms of these heterobimetallic complexes show multiple one-electron transfer processes, from two to four redox events depending on the M-Cr pair.

The participation of the valence orbitals of actinides in bonding has been debated for decades. Recent experimental and computational investigations demonstrated the involvement of 6p, 6d and/or 5f orbitals in bonding. However, structural and spectroscopic data, as well as theory, indicate a decrease in covalency across the actinide series, and the evidence points to highly ionic, lanthanide-like bonding for late actinides. Here we show that chemical differentiation between californium and lanthanides can be achieved by using ligands that are both highly polarizable and substantially rearrange on complexation. A ligand that suits both of these desired properties is polyborate. We demonstrate that the 5f, 6d and 7p orbitals are all involved in bonding in a Cf(III) borate, and that large crystal-field effects are present. Synthetic, structural and spectroscopic data are complemented by quantum mechanical calculations to support these observations.