Rubber trees (Hevea brasiliensis (Willd.) Muell.Arg.) are cultivated for latex production, but they also produce timber for industry, and logging residues can be used for power generation. In this study, we determined the biomass of above- and below-ground tree compartments (leaves, branches <3 cm in diameter, branches 3–5 cm in diameter, stumps and roots) of 20-, 25-, and 30-year-old rubber tree plantations in Songkhla province, southern Thailand, at the clear-cutting stage. We also studied the nutrient content and heating value of the compartments. The total dry mass (including leaves, branches, stems and stumps and roots) of the mature rubber wood stands was 157–289 Mg ha−1. The residual harvestable dry mass without leaves (39–68 Mg ha−1, branches <5 cm in diameter, stumps and roots) comprised 25% of the total dry mass. Nutrient concentrations were highest in the leaves, followed by small branches. In most cases, the stems and larger branches had similar concentrations. One ton of rubber tree biomass (leaves and stumps and roots included) contained an average of 2.4 kg N, 0.2 kg P, 3.4 kg K, and 4.8 kg Ca. Depending on the biomass of the stands, the rubber trees had 380–700 kg, 36–64 kg, 530–980 kg, and 750–1360 kg of bound N, P, K, and Ca per hectare, respectively. The effective heating value of the stumps and roots was the lowest (17.65 MJ kg−1). Stems and branches were similar (18.37–18.58 MJ kg−1), and leaves were the highest (20.34 MJ kg−1). The unharvested residual biomass in southern Thailand is a potential fuel source for power generation.

No abstract

The rubber tree (Hevea brasiliensis) is cultivated for latex production, but its timber is used in industry and its logging residues can be used for power generation. The reliable estimation of biomass is basis for operational calculations. In this study, allometric biomass equations for fresh and dry biomass of the aboveand belowground non industrial tree components of mature rubber tree (leaves, branches < 3 cm in diameter, branches 3-5 cm in diameter, stumps with roots, stem) at the clear-cutting phase were developed. The models were based on 18 sample trees of clone 600 harvested in Songkhla province, southern Thailand. Diameter at breast height (DBH), height (H) and their combination (DBH 2 *H) were tested as independent variables. In the models, easily measurable DBH gave a considerably higher coefficient of determination than H. Combining both DBH and H in the models did not improve the equations. The equations provided logical biomass predictions and they had high coefficient of determination. Fresh mass equations can be used in predicting the value of trees in local markets and dry mass equations for estimating the amount of residual biomass in mature rubber tree plantations in southern Thailand.

Work safety in the forestry industry, where chainsaws are used for tree felling, continues to be a top priority. The mobility of workers involved in chainsaw operations between Europe and Asia has become more common in today’s global workplace. Therefore, sharing knowledge about the types of work safety issues found in both regions can be beneficial. Increased knowledge and safety awareness in the workplace can contribute to a reduction in chainsaw accidents. This paper identifies and addresses four key related areas, namely: regulatory frameworks; chainsaw accidents; personal protective equipment and chainsaw training. Information for both regions was evaluated via interviews, questionnaires, direct observation, desk studies, field studies and descriptive statistical analysis. A total of 234 participants responded to the main research questionnaire, which resulted in data analysis of significant questions related to the use of personal protective equipment (PPE) and possible causes of accidents. Key findings included a need for more information relating to the effect of regulations in individual countries and chainsaw accident and fatality statistics within Asia. A requirement for further research into the suitability of PPE used in Asia was identified. Inadequate training was seen as a primary factor causing accidents in Asia, while in Europe, it was due to chainsaw operators taking shortcuts. Inadequate workplace supervision and a lack of uniform and affordable training provision were common issues identified within both regions. Field tests carried out in accordance with the International/European chainsaw (ICC/ECC) qualification standards of the »non-profit« Awarding Body Association (ABA) International were successful in demonstrating the benefits of uniform training to participants in Europe and Asia. Overall, the study raises awareness of the fatal consequences of risk-taking behaviour to work safety, requiring a better understanding of the problem from a social psychology perspective. It identifies the self-employed or temporary worker groups as high-risk categories in both regions, with younger workers seen to be more at risk of injury in Asia and older workers more at risk in Europe. The findings demonstrate that, while there are differences between the two regions (at least within the participating countries), it is essential to provide quality education and raise skills by training and promotion of supervision in order to prevent chainsaw accidents. This can lead to the development of the building blocks of a holistic approach to safety in forestry work, which, as shown in this paper, can result in a decrease in the occurrence of accidents.

No abstract

No abstract

Occupational safety is generally known to be low in forestry work. A similar situation may be found in Southeast Asian countries, where health and safety aspects are not commonly taken care of so rigorously. However, there is also a lack of primary data which could be suitable for evaluating such issues. The auditing reports of FCS certification are a source of useful information to evaluate and analyze health and safety concerns in forestry work. This paper addressed the coverage of available information, classified the risk factors uniformly from different certifying body criteria, compared occurrence of risk factors in groups and checked for dependencies in data. The key findings are that the main issues were those related to the organizations’ failures to protect the workers and to the lack of awareness of safety. In turn, these may explain the high incidence of forestry-related work accidents in Southeast Asia.

The authors wish to make the following corrections to their paper [...]