The development of nanocrystals has been intensively pursued, not only for their fundamental scientific interest, but also for many technological applications. The synthesis of monodisperse nanocrystals (size variation <5%) is of key importance, because the properties of these nanocrystals depend strongly on their dimensions. For example, the colour sharpness of semiconductor nanocrystal-based optical devices is strongly dependent on the uniformity of the nanocrystals, and monodisperse magnetic nanocrystals are critical for the next-generation multi-terabit magnetic storage media. For these monodisperse nanocrystals to be used, an economical mass-production method needs to be developed. Unfortunately, however, in most syntheses reported so far, only sub-gram quantities of monodisperse nanocrystals were produced. Uniform-sized nanocrystals of CdSe (refs 10,11) and Au (refs 12,13) have been produced using colloidal chemical synthetic procedures. In addition, monodisperse magnetic nanocrystals such as Fe (refs 14,15), Co (refs 16-18), gamma-Fe(2)O(3) (refs 19,20), and Fe(3)O(4) (refs 21,22) have been synthesized by using various synthetic methods. Here, we report on the ultra-large-scale synthesis of monodisperse nanocrystals using inexpensive and non-toxic metal salts as reactants. We were able to synthesize as much as 40 g of monodisperse nanocrystals in a single reaction, without a size-sorting process. Moreover, the particle size could be controlled simply by varying the experimental conditions. The current synthetic procedure is very general and nanocrystals of many transition metal oxides were successfully synthesized using a very similar procedure.

We studied the kinetics of the formation of iron oxide nanocrystals obtained from the solution-phase thermal decomposition of iron-oleate complex via the "heating-up" process. To obtain detailed information on the thermal decomposition process and the formation of iron oxide nanocrystals in the solution, we performed a thermogravimetric-mass spectrometric analysis (TG-MS) and in-situ magnetic measurements using SQUID. The TG-MS results showed that iron-oleate complex was decomposed at around 320 degrees C. The in-situ SQUID data revealed that the thermal decomposition of iron-oleate complex generates intermediate species, which seem to act as monomers for the iron oxide nanocrystals. Extensive studies on the nucleation and growth process using size exclusion chromatography, the crystallization yield data, and TEM showed that the sudden increase in the number concentration of the nanocrystals (burst of nucleation) is followed by the rapid narrowing of the size distribution (size focusing). We constructed a theoretical model to describe the "heating-up" process and performed a numerical simulation. The simulation results matched well with the experimental data, and furthermore they are well fitted to the well-known LaMer model that is characterized by the burst of nucleation and the separation of nucleation and growth under continuous monomer supply condition. Through this theoretical work, we showed that the "heating-up" and "hot injection" processes could be understood within the same theoretical framework in which they share the characteristics of nucleation and growth stages.

CommunicationsMonodisperse magnetic iron oxide nanoparticles with a continuous size spectrum of 6-13 nm were produced by controlled growth on previously synthetisized monodisperse nanoparticle seeds. The detailed synthetic procedure and characterization is described in the communication by T. Hyeon et al. on the following pages.