Five spectrophotometric methods and one fluorimetric method have been developed and validated for the analysis of clozapine. The spectrophotometric methods were based on the charge-transfer complexation reaction between clozapine as electron donor and each of iodine as sigma-acceptor or 7,7,8,8-tetracyanoquinondimethane (TCNQ), 2,3-dichloro-5,6-dicyano-1,4-benzo-quinone (DDQ), tetracyanoethane (TCNE), and p-chloranilic acid (pCA) as pi-acceptors. The obtained complexes were measured spectrophotometrically at 365, 843, 460, 414, and 520 nm for iodine, TCNQ, DDQ, TCNE, and pCA, respectively. The fluorimetric method was based on the oxidation of clozapine in the presence of perchloric acid by cerium (IV), and subsequent measuring the fluorescence of the produced cerium (III) fluorimetrically at lambda(excitation) 260 and lambda(emission) 355 nm. Under the optimum assay conditions, Beer's law was obeyed at concentrations ranged from 4-200 microg mL(-1) for the spectrophotometric methods and from 24-250 ng mL(-1) for the fluorimetric method. The limits of detection for the spectrophotometric methods were 1.12, 1.76, 2.22, 0.95, and 13.26 microg mL(-1) for iodine, TCNQ, DDQ, TCNE, and pCA, respectively. The limit of detection for the fluorimetric method was 6.69 ng mL(-1). The proposed methods were successfully applied to the analysis of clozapine in tablets with good recoveries. The fluorimetric method could also be applied to the analysis of clozapine in spiked urine samples. The molar ratios and the reaction mechanisms were investigated.

Two simple and sensitive spectrofluorimetric methods were developed for determination of three water-soluble vitamins (B1, B2, and B6) in mixtures in the presence of cyanocobalamin. The first one was for thiamine determination, which depends on the oxidation of thiamine HCl to thiochrome by iodine in an alkaline medium. The method was applied accurately to determine thiamine in binary, ternary, and quaternary mixtures with pyridoxine HCl, riboflavin, and cyanocobalamin without interference. In the second method, riboflavin and pyridoxine HCl were determined fluorimetrically in acetate buffer, pH 6. The three water-soluble vitamins (B1, B2, and B6) were determined spectrofluorimetrically in binary, ternary, and quaternary mixtures in the presence of cyanocobalamin. All variables were studied in order to optimize the reaction conditions. Linear relationship was obeyed for all studied vitamins by the proposed methods at their corresponding lambda(exc) or lambda(em). The linear calibration curves were obtained from 10 to 500 ng/mL; the correlation ranged from 0.9991 to 0.9999. The suggested procedures were applied to the analysis of the investigated vitamins in their laboratory-prepared mixtures and pharmaceutical dosage forms from different manufacturers. The RSD range was 0.46-1.02%, which indicates good precision. No interference was observed from common pharmaceutical additives. Good recoveries (97.6 +/- 0.7-101.2 +/- 0.8%) were obtained. Statistical comparison of the results with reported methods shows excellent agreement and indicates no significant difference in accuracy and precision.