The piezoelectric effect is widely applied in pressure sensors for the detection of dynamic signals. However, these piezoelectric-induced pressure sensors have challenges in measuring static signals that are based on the transient flow of electrons in an external load as driven by the piezopotential arisen from dynamic stress. Here, we present a pressure sensor with nanowires/graphene heterostructures for static measurements based on the synergistic mechanisms between strain-induced polarization charges in piezoelectric nanowires and the caused change of carrier scattering in graphene. Compared to the conventional piezoelectric nanowire or graphene pressure sensors, this sensor is capable of measuring static pressures with a sensitivity of up to 9.4 × 10 kPa and a fast response time down to 5-7 ms. This demonstration of pressure sensors shows great potential in the applications of electronic skin and wearable devices.

Noninvasive and real‐time cuffless blood pressure (BP) measurement realizes the idea of unobtrusive and continuous BP monitoring which is essential for diagnosis and prevention of cardiovascular diseases associated with hypertension. In this paper, a wearable sensor patch system that integrates flexible piezoresistive sensor (FPS) and epidermal electrocardiogram (ECG) sensors for cuffless BP measurement is presented. By developing parametric models on the FPS sensing mechanism and optimizing operational conditions, a highly stable epidermal pulse monitoring method is established and beat‐to‐beat BP measurement from the ECG and epidermal pulse signals is demonstrated. In particular, this study highlights the compromise between sensor sensitivity and signal stability. As compared with the current optical‐based cuffless BP measurement devices, the sensing patch requires much lower power consumption (3 nW) and is capable of detecting subtle physiological signal variations, e.g., pre and postexercises, thus providing a promising solution for low‐power, real‐time, and home‐based BP monitoring.

Wearable photoplethysmogram (PPG) sensors offer convenient and informative measurements for evaluating daily physiological states of individuals. In this work, epidermal and flexible near-infrared (NIR) PPG sensors integrating a low-power, high-sensitivity organic phototransistor (OPT) with a high-efficiency inorganic light-emitting diode are developed. By exploiting an organic bulk heterojunction active layer and a bilayer gate dielectric design, a low voltage (<3 V) operated OPT with NIR responsivity as high as 3.5 × 10 A W and noise equivalent power of 1.2 × 10 W Hz is achieved, greatly surpassing commercial available silicon-based photodetectors. In addition, the ultrathin encapsulation structure renders the device highly flexible and allows transfer printing of the device directly onto human skin. It is demonstrated that the epidermal/flexible PPG sensors are capable of continuously monitoring heart rate variability and precisely tracking the changes of pulse pressure at different postures of human subjects with the aid of electrocardiogram monitoring, exhibiting more reliable performance than commercial PPG sensors while consuming less power. The study suggests that the hybrid PPG sensor design may provide a promising solution for low-power, real-time physiological monitoring.

A versatile flexible piezoresistive sensor should maintain high sensitivity in a wide linear range, and provide a stable and repeatable pressure reading under bending. These properties are often difficult to achieve simultaneously with conventional filler-matrix composite active materials, as tuning of one material component often results in change of multiple sensor properties. Here, a material strategy is developed to realize a 3D graphene-poly(dimethylsiloxane) hollow structure, where the electrical conductivity and mechanical elasticity of the composite can be tuned separately by varying the graphene layer number and the poly(dimethylsiloxane) composition ratio, respectively. As a result, the sensor sensitivity and linear range can be easily improved through a decoupled tuning process, reaching a sensitivity of 15.9 kPa in a 60 kPa linear region, and the sensor also exhibits fast response (1.2 ms rising time) and high stability. Furthermore, by optimizing the density of the graphene percolation network and thickness of the composite, the stability and repeatability of the sensor output under bending are improved, achieving a measurement error below 6% under bending radius variations from -25 to +25 mm. Finally, the potential applications of these sensors in wearable medical devices and robotic vision are explored.

A key challenge in textile sensors is to adequately solve the hysteresis for more broad and exacting applications. Unlike the conventional strategy in integrating elastic polymers into the textile, the hysteretic issue is critically addressed here through the structural design of yarns to provide a twisting force. The underlying mechanism is fully discussed based on theory and modeling, which are in good agreement with experimental data. Impressively, the pressure sensor outperforms almost all reported textile‐based sensors in terms of recovery index, which refers to the ability to overcome the lagged deformation reflected by the hysteresis (5.3%) and relaxation time (2 ms). Besides, the sensor superiority is also demonstrated by way of its ultrafast response time (2 ms). Thanks to these merits, this pressure sensor is demonstrated to be capable of monitoring epidermal pulses and meanwhile shows great potential to advance the standardization and modernization of pulse palpation in traditional Chinese medicine.

Mn-based nanoparticles (NPs) have emerged as new class of probes for magnetic resonance imaging due to the impressive contrast ability. However, the reported Mn-based NPs possess low relaxivity and there are no immunotoxicity data regarding Mn-based NPs as contrast agents. Here, we demonstrate the ultrahigh relaxivity of water protons of 8.26 mM−1s−1 from the Mn3O4 NPs synthesized by a simple and green technique, which is twice higher than that of commercial gadolinium (Gd)-based contrast agents (4.11 mM−1s−1) and the highest value reported to date for Mn-based NPs. We for the first time demonstrate these Mn3O4 NPs biocompatibilities both in vitro and in vivo are satisfactory based on systematical studies of the intrinsic toxicity including cell viability of human nasopharyngeal carcinoma cells, normal nasopharyngeal epithelium, apoptosis in cells and in vivo immunotoxicity. These findings pave the way for the practical clinical diagnosis of Mn based NPs as safe probes for in vivo imaging.

Natural wood possesses a unique 3D microstructure containing hierarchical interconnected channels along its growth direction. This study reports a facile processing strategy to utilize such structure to fabricate carbon/silicone composite based flexible pressure sensors. The unique contribution of the multichannel structure on the sensor performance is analyzed by comparing the pressure response of the vertically cut and horizontally cut composite structures. The results show that the horizontally cut composite based sensors exhibit much higher sensitivity (10.74 kPa ) and wider linear region (100 kPa, R = 99%), due to their rough surface and largely deformable microstructure. Besides, the sensors also show little hysteresis and good cycle stability. The overall outstanding sensing properties of the sensors allow for accurate continuous measurement of human pulse and respiration, benefiting the real-time health signal monitoring and disease diagnoses.

Monoclinic Gd2O3:Eu(3+) nanoparticles (NPs) possess favorable magnetic and optical properties for biomedical application. However, how to obtain small enough NPs still remains a challenge. Here we combined the standard solid-state reaction with the laser ablation in liquids (LAL) technique to fabricate sub-10 nm monoclinic Gd2O3:Eu(3+) NPs and explained their formation mechanism. The obtained Gd2O3:Eu(3+) NPs exhibit bright red fluorescence emission and can be successfully used as fluorescence probe for cells imaging. In vitro and in vivo magnetic resonance imaging (MRI) studies show that the product can also serve as MRI good contrast agent. Then, we systematically investigated the nanotoxicity including cell viability, apoptosis in vitro, as well as the immunotoxicity and pharmacokinetics assays in vivo. This investigation provides a platform for the fabrication of ultrafine monoclinic Gd2O3:Eu(3+) NPs and evaluation of their efficiency and safety in preclinical application.