The recently introduced technique of osseodensification for dental implant involves the use of special drills (Densah) run in a counterclockwise direction at the osteotomy site. It is claimed that this causes expansion of the osteotomy site, and increases density of the bone in immediate vicinity of the osteotomy. We reviewed published papers on the primary stability attained using this drilling technique. As a secondary finding, the bone to implant contact (BIC) and the bone area fraction occupancy (BAF) was also compared between the conventional drilling protocol and the osseodensification protocol, among these articles. A Systematic search was performed in PubMed-Medline, Embase and Google Scholar for clinical/animal studies up to November 2018. A total of 12 articles, from a database of 132 articles, consisting of 8 animal histologic studies, 2 human based clinical studies, 1 case series and 1 case report were assessed. 10/12 articles measured the insertion torque values, 7/12 articles measured the BIC and 6/12 articles estimated the BAF between the two techniques. Quality assessment of 8 studies performed using ARRIVE guidelines showed that 6/8 studies had a high score. An average increase in the insertion torque, BIC and BAF was noted in the osseodensification group as compared to the conventional drilling group. Since most of these studies are non-clinical, it can be inferred that osseodensification is an efficient way to enhance primary stability of implants in low density bone in an animal model. However, extrapolation to long term clinical success cannot be ascertained until further evidence becomes available.
Work-related musculoskeletal disorders can be reduced by performing a few simple chair-side stretches. These stretches can help prevent the finger muscle fatigue during SRP and thus, increase its efficacy.
Aim Dimensional changes of the alveolar bone are often noted in horizontal and vertical planes as a sequel to tooth extraction, particularly in the maxillary posterior region due to alveolar bone resorption combined with pneumatization of the sinus. The aim of this retrospective study was to quantitatively assess the maxillary residual alveolar ridge using cone beam computed tomography (CBCT) scans. Materials and methods A total of 349 edentulous sites from 250 CBCTs were evaluated. The apico-coronal bone height and bucco-palatal crest width were measured in sagittal and coronal slices, respectively. Additionally, the obliqueness of the sinus floor at the edentulous sites was also evaluated. Results One hundred and twelve (55.45%) of the molar and 74 (54.42%) of the premolar sites had a horizontal ridge dimension \ 6 mm, whereas 137 (67.83%) of the molar and 61 (44.86%) of the premolar sites showed an apico-coronal height \ 8 mm. Furthermore, 183 (54.14%) of the evaluated sites had an oblique sinus floor morphology. Conclusion Additional augmentative procedures are thus required in a high percentage of the population at the edentulous maxillary posterior site for rehabilitation using a standard dimension implant. This study stresses on the need for a three-dimensional CBCT prior to implant surgery for proper treatment planning.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.