The purpose of this study was the preparation, characterization and application of high-performance activated carbons (ACs) derived from oily sludge through chemical activation by KOH. The produced ACs were characterized using iodine number, N2 adsorption-desorption, Fourier-transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM). The activated carbon prepared under optimum conditions showed a predominantly microporous structure with a BET surface area of 2263 m2 g−1, a total pore volume of 1.37 cm3 g−1 and a micro pore volume of 1.004 cm3 g−1. The kinetics and equilibrium adsorption data of phenol fitted well to the pseudo second order model (R2 = 0.99) and Freundlich isotherm (R2 = 0.99), respectively. The maximum adsorption capacity based on the Langmuir model (434 mg g−1) with a relatively fast adsorption rate (equilibrium time of 30 min) was achieved under an optimum pH value of 6.0. Thermodynamic parameters were negative and showed that adsorption of phenol onto the activated carbon was feasible, spontaneous and exothermic. Desorption of phenol from the adsorbent using 0.1 M NaOH was about 87.8% in the first adsorption/desorption cycle and did not decrease significantly after three cycles. Overall, the synthesized activated carbon from oily sludge could be a promising adsorbent for the removal of phenol from polluted water.
Preparation and characterization of activated carbons (ACs) from oily sludge by physical and chemical activation using steam, ZnCl2 and FeCl3 were investigated. The characteristics of produced adsorbents were determined by iodine number, Brunauer–Emmett–Teller (BET) equation, Fourier transform infrared spectrometry and scanning electron microscopy analyses. Batch adsorption experiments for phenol and phosphate were performed to evaluate the efficiency of adsorbents. The optimum porous structure of adsorbents with a BET surface area of 1,259 m2 g−1, total pore volume of 1.22 cm3 g−1 and iodine number of 994 mg g−1 was achieved by ZnCl2 activation at 500 °C and impregnation ratio of 1:1. The adsorption data were well fitted to the pseudo-second-order kinetic model (R2>0.99) and Freundlich isotherm (R2>0.99). The maximum adsorption capacity of phenol (238 mg g−1) and phosphate (102 mg g−1) based on the Langmuir model was achieved at pH of 6.0 and adsorbent dose of 1 g L−1. Thermodynamic parameters were negative and showed that adsorption of phenol and phosphate onto the AC was feasible, spontaneous and exothermic. The results suggested that prepared AC was an effective adsorbent for removal of phenol and phosphate ions from the polluted water.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.