Currently, lignin is mainly produced in pulping processes, but it is considered as an under-utilized chemical since it is being mainly used as a fuel source. Lignin contains many hydroxyl groups that can participate in chemical reactions to produce value-added products. Flocculants, adsorbents, and dispersants have a wide range of applications in industry, but they are mainly oil-based chemicals and expensive. This paper reviews the pathways to produce water soluble lignin-based flocculants, adsorbents, and dispersants. It provides information on the recent progress in the possible use of these lignin-based flocculants, adsorbents, and dispersants. It also critically discusses the advantages and disadvantages of various approaches to produce such products. The challenges present in the production of lignin-based flocculants, adsorbents, and dispersants and possible scenarios to overcome these challenges for commercial use of these products in industry are discussed.

No abstract

In this research, a novel polysaccharide-based bionanocomposite film was prepared via dispersion casting method. Nano-silicon dioxide (SiO2-N) was incorporated into soluble soybean polysaccharide (SSPS) at different concentrations (i.e., 0%, 1%, 3%, and 5% w/w dried SSPS). Mechanical (tensile strength, elongation at break, and Young’s modulus), physical (moisture content, water solubility, and moisture uptake), and barrier properties of bionanocomposite films were evaluated. Incorporation of 5% SiO2-N to SSPS matrix decreased water vapor permeability (WVP) from 7.96×10−11 to 4.75×10−11 g m−1 s−1 Pa−1 and oxygen permeability from 215 to 96 cm3 µm m−2 day−1 atm−1. Heat seal strength and mechanical properties of SSPS films were improved. Moisture sorption isotherm of SSPS films supported by SiO2-N was shifted to lower moisture content, and monolayer moisture content of the films decreased significantly (p<0.05). In summary, SiO2-N is a potential filler in SSPS-based films for packaging materials.

Lignin is the richest source of renewable aromatics and has immense potential for replacing synthetic chemicals. The limited functionality of lignin is, however, challenging for its potential use, which motivates research for creating advanced functional lignin-derived materials. Here, we present an aqueous-based acid precipitation method for preparing functional lignin nanoparticles (LNPs) from carboxy­methylated or carboxy­pentylated lignin. We observe that the longer grafted side chains of carboxy­pentylated lignin allow for the formation of larger LNPs. The functional nanoparticles have high tolerance against salt and aging time and well-controlled size distribution with R h ≤ 60 nm over a pH range of 5–11. We further investigate the layer-by-layer (LbL) assembly of the LNPs and poly­(allylamine hydrochloride) (PAH) using a stagnation point adsorption reflectometry (SPAR) and quartz crystal microbalance with dissipation (QCM-D). Results demonstrate that LNPs made of carboxy­pentylated lignin (i.e., PLNPs with the adsorbed mass of 3.02 mg/m2) form a more packed and thicker adlayer onto the PAH surface compared to those made of carboxy­methylated lignin (i.e., CLNPs with the adsorbed mass of 2.51 mg/m2). The theoretical flux, J, and initial rate of adsorption, (dΓ/dt)0, analyses confirm that 22% of PLNPs and 20% of CLNPs arriving at the PAH surface are adsorbed. The present study provides a feasible platform for engineering LNPs with a tunable size and adsorption behavior, which can be adapted in bionanomaterial production.