Main advantages of diesel engine are low fuel consumption coupled with high specific power output. However, benchmark Noise, Vibration and Harshness (NVH) of its counterpart (Gasoline), future stringent emission norms and overall system cost poses tough challenges. In a growing market like India, these benefits of diesel attract the buyer over its counterpart. Diesel engines are known for its heavy visible black smoke. The black smoke formation is more prominent in lower engine speed. This is due to lower injection pressure and the system limitation in conventional injection system and less air availability. Introduction of the common rail injection technology overcomes this difficulty by allowing the injection pressure to build irrespective of the engine speed. However, improving the air flow is a challenge. Generally waste gate turbo chargers are optimized for higher engine speed to match the rated engine performance, but compromising the lower engine speed performance. The use of Variable Geometry turbo charging (VGT), increase in number of valves per cylinder, two stage turbo charging are some of the solutions to this problem but it involves additional cost and fundamental design changes. Hence, it was a challenge to come up with a strategy to overcome this problem without any cost impact. Multiple injection strategy is one of the tools which improve the engine torque without the penalty of smoke. In this paper, a Multi Utility Vehicle (MUV) powered by a 2.5Ldiesel common rail engine, low end performance was effectively improved by this strategy. Current engine has BOSCH 2nd generation common rail system with waste gate Turbocharger. Torque at full load in lower engine speed was improved by introducing the early pilot with relatively higher quantity. However, in the part load, this pilot quantity was split into two successive pilot injections. Selection of pilot separation was optimized in such a way that Noise and Smoke levels are maintained or improved. In part load, improvement in smoke and BSFC was achieved without sacrificing noise level. Engine level trials were conducted with cylinder pressure and Noise Measurement with AVL Indicom. The Concept of Design of experiment (DOE) was used to minimize the number of iteration and for analysis of results. The vehicle performance, pass by noise were found to be improved.
Present investigation addresses the use of neat, indigenous biodiesel (B100) in a sports utility vehicle (SUV) with second generation common rail technology. Current research determines the effect of biodiesel (B100) on performance & emission of modern diesel engine, equipped with diesel oxidation catalyst. Biodiesel used in this study were Pongamea Methyl Ester (PME) & Jatropha Methyl Ester (JME) derived from vegetable oil. Fuel related aspects for these two raw material and its effects on engine characteristics were discussed. Both engine & vehicle level tests had been carried out with the aim of obtaining performance characteristics such as brake specific fuel consumption, brake thermal efficiency, brake power, exhaust gas temperature, & emissions such as CO, THC, NOx, smoke opacity to evaluate and compute the behaviors of diesel engine running on PME & JME. Comparative vehicle performance like drivability, gradeability and noise was also measured between biodiesel and diesel. Experimental results revealed that significant reduction in power was observed through out the operating range in both JME & PME, because of its lower heating value. Between this two biodiesel, there was a visible difference in power drop. Engine exhaust gas emission like Hydrocarbon (HC), Carbon monoxide (CO), & Smoke emission reduce significantly, when engine runs with biodiesel (JME & PME) meanwhile using of B100 causes increase in Nitrogen oxide (NOx) emission. Particulate matter was significantly lower than those of a vehicle running on fossil diesel. However loss in power, when using biodiesel has been regained by increasing the fuelling & optimizing the combustion parameters like rail pressure, injection timing & duration. Based on the study it is observed that B100 can be used as fuel in diesel engine without any hardware modification, but only by remapping the CRDe system.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.