The main advantage of multiphase frequency controlled AC drives is that they have more control resources than the 3-phase ones. The increase of the inverter system phase number (i.e. the number of the phases) more than five together with the joint application of the phase-pole control method and the classical principle of AC motor frequency control in these systems allow to improve considerably a number of the drive technical-andeconomic characteristics (speed of response, reliability, manufacturing cost, etc.).
The paper presents the results of studies of the structure and properties of a wire with a diameter of 0.5 mm from an alloy of the Al-REM system with a rare-earth metal content of 7-9%. Wire obtained as a result of the implementation of the technology of its manufacture using the methods of casting into an electromagnetic mold (EMM), continuous extruding and drawing.The rheological properties of the metal of continuously cast round billets from the experimental alloy obtained using an electromagnetic mold are determined. The modeling and analytical assessment of the possibility of carrying out the process of combined rolling-extruding (CRE) of such billets in a closed boxtype roll groove of a continuous extruding unit are carried out. The features of metal shaping have been studied. The temperature-speed and technological parameters was found at which the CRE process can be carried out in a stable mode of operation. Data have been obtained for the forces acting on the die and rolls and the moments on the rolls during rolling-extruding.The results of experimental studies of the process of obtaining longish deformed semi-finished products from an experimental alloy on the laboratory unit CRE-200 and the pilot plant unit CRE-400 are presented. The structure of the metal has been studied; data on the ultimate tensile strength, yield strength, relative elongation, and electrical resistivity of hot-extruded rods and wires in cold-worked and annealed states have been obtained.It was found that the proposed processing modes make it possible to obtain by the method of combined rolling-extruding rods with a diameter of 9 mm in industrial conditions from longish billets with a diameter of 18 mm, cast by means of EMM. Wire in a cold-worked and annealed state with a diameter of 0.5 obtained by drawing from the rods with a diameter of 9 mm from an experimental alloy of the Al-REM system containing 7-9 rare earth metals with the required physical and mechanical properties.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.