Effects of nitrogen (M) and water supply on grapevine leaf transmittance and canopy reflectance were studied over 2 years (2009)(2010) in two vineyards planted with cvs. Cabernet Sauvignon and Xinomavro (Vitis vinifera L.) located in northern Greece. Three N (0, 60 and 120 kg ha -1 ) and two irrigation (irrigated at 70 % of crop evapotranspiration and non-irrigated) treatments were managed in triplicate in randomized blocks. Measurements with two transmittance-based chlorophyll meters (CM: SPAD-502 and CCM-200) and two active canopy sensors (Crop Circle ACS-210; amber band and Crop Circle ACS-430; red and red edge bands) were conducted on four and two growth stages, respectively. Fertilization increased leaf N and chlorophyll concentrations, as well as CM readings and vegetation indices. The CCM and SPAD values did not vary across growth stages and better estimated leaf N and chlorophyll concentrations in Cabernet Sauvignon than in Xinomavro. The SPAD readings provided better predictions of leaf N concentration. The vegetation indices of the ACS-430 sensor correlated with leaf N and chlorophyll concentrations and dormant wood in Cabernet Sauvignon; the red edge-based indices were generally more efficient than the red-based indices. Consistent relationships were observed for all ACS-430 indices with yield and for red edge-based indices with total phenols early in the season for both vineyards. The correlation between ACS-210 sensor indices and vine properties was low. These results showed that the two technologies examined could provide information on grapevine performance early in the season but have limitations that may restrict their use in vineyards because the acquired relationships were not consistent across vineyards and instruments.

Tannin accumulation and composition were determined in skins and seeds isolated from Vitis vinifera cv. Syrah grapes submitted to contrasting water regimes under semiarid climatic conditions. Three irrigation treatments were conducted, starting at berry set through harvest of two growing seasons, 2011 and 2012: irrigation at 100% of crop evapotranspiration ETc (FI), irrigation at 50% of ETc (DI) and non-irrigated (NI). Seed total tannins did not vary with maturity but those of skins underwent a progressive decline (especially in 2011), expressed both on a fresh weight and on a per berry basis. Skin total tannin concentration and content per berry were increased under NI and DI conditions, mainly in 2012. In contrast, seed total tannins (in 2012) and flavan-3-ol monomers and tannin oligomers (both years) were higher in the fully irrigated vines (FI). Skin polymer size increased during ripening, NI and DI skins showing higher mean degree of polymerization (mDP) compared to FI at harvest. NI was also associated with a lower percentage of galloylation (%G) in skin oligomeric fraction (in 2012) and a lower percentage of prodelphinidins in the skin polymeric fraction (both years) at harvest. The mDP and %G of seed extracts did not vary during ripening and were higher in NI but only in 2012. According to the results, management of vine water status was shown to influence tannin amount and composition of Syrah grapes grown under semiarid conditions.

Irrigation proved to be an effective technique to control anthocyanin content in Syrah grapes under semiarid conditions. However, anthocyanin accumulation pattern should be considered by winemakers to appropriately select harvest time for improved wine colour.

Aim: The aim of this study was to determine and compare anthocyanin content and profile under variable irrigation regimes in four red grape cultivars (Vitis vinifera L.), the Greek indigenous cvs. Agiorgitiko and Xinomavro, alongside Syrah and Grenache noir.Methods and results: Three irrigation treatments were applied in a 6-year-old vineyard comprising all four varieties in a block design, starting at bunch closure (E-L 32) through harvest of 2012 and 2013: full irrigation (FI) at 100% of crop evapotranspiration (ETc), deficit irrigation (DI) at 50% of ETc and non-irrigated (NI). The identification of the compounds was performed by HPLC. Results showed that, under the hot summer conditions of the Greek climate, the four cultivars had a similar response regarding vigor and yield parameters, with values increasing with water supply. Anthocyanin concentration was maximized under non-irrigated conditions in all cultivars, but anthocyanin profile and relative distribution of individual anthocyanins among irrigation treatments showed a strong cultivar effect.Conclusion: Xinomavro seemed to favor the synthesis of more stable forms of anthocyanins under limited water supply (acylated over non-acylated and tri-oxygenated & methoxylated on the B-ring over di-oxygenated & hydroxylated) while Agiorgitiko had an opposite behavior, which might imply a need for a different irrigation strategy.Significance and impact of the study: To the best of our knowledge, this is the first comparative report of anthocyanin composition and profile in berry skin, under contrasting water status, for the two most important red winegrapes of Greece.

Precision viticulture employs various sensors for assessing nondestructively key parameters in vineyards. One of the most promising technologies for this purpose is the laser scanner sensor. Laser scanner uses the LiDAR (Light Detection And Ranging) method for the calculation of the distance from the sensor. However, the number of cultivation operations affects the credibility of sensors such as the laser scanner. The main aim of this study was to assess a laser scanner sensor at different measurement settings for estimating pruning wood parameters on two wine grape cultivars (Sauvignon Blanc and Syrah) that received different numbers of farming interventions. The experiment was conducted in the two vineyards situated in the same farm for two successive years (2014 and 2015). The results indicated that the use of a laser scanner in the Syrah vineyard presented more accurate results (r = 0.966 in 2014 and r = 0.806 in 2015) when compared to the Sauvignon Blanc one (r = 0.839 in 2014 and r = 0.607 in 2015) regarding pruning wood parameters estimation. Different measurement settings and weather conditions had different effects on the accuracy of the sensor. It can be concluded that the laser scanner is a very helpful sensor for estimating pruning wood parameters in vineyards.