Using biodiesel fuel in diesel engines for heavy-duty transport is important to meet the stringent emission regulations. Biodiesel is an oxygenated fuel and its physical and chemical properties are close to diesel fuel, yet there is still a need to analyze and tune the fuel injection parameters to optimize the combustion process and emissions. A four-injections strategy was used: two pilots, one main and one post injection. A highly advanced SOI decreases the NOx and the compression work but makes the combustion process less efficient. The pilot injection fuel mass influences the combustion only at injection close to the top dead center during the compression stroke. The post injection has no influence on the compression work, only on the emissions and the indicated work. An optimal injection strategy was found to be: pilot SOI 19.2 CAD BTDC, pilot injection fuel mass 25.4%; main SOI 3.7 CAD BTDC, main injection fuel mass 67.3% mg; post SOI 2 CAD ATDC, post injection fuel mass 7.3% (the injection fuel mass is given as a percentage of the total fuel mass injected). This allows the indicated work near the base case level to be maintained, the pressure rise rate to decrease by 20% and NOx emissions to decrease by 10%, but leads to a 5% increase in PM emissions.
Modern research in the area of internal combustion engines is focused on searching and investigating the technologies that will improve fuel efficiency and decrease emissions. The application of dual-fuel engines is considered a potential solution to these problems. In the dual-fuel engine, the natural gas-air mixture is ignited by a small amount of diesel fuel directly injected into a combustion chamber. This paper aims to develop a detailed chemistry mechanism for 3D simulation of the combustion process of a dual-fuel engine, providing sufficient convergence with the experimental data. It should be noted that sufficient convergence must also be provided in terms of such parameters as pilot fuel ignition delay and premixed air-fuel mixture flame propagation speed. In the course of the research, the analysis of the most commonly used detailed chemistry mechanisms for calculation of the combustion process and mechanisms’ disadvantages was performed. The results obtained with the use of the detailed mechanisms were compared with the results obtained without using detailed chemistry and with the experimental data as well.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.