In this study, both modeling and experimental approaches are used to demonstrate that downstream volumetric heating of electrospun fibers during melt electrospinning can result in markedly decreased fiber diameters. Previous melt electrospinning techniques were limited to production of micron‐sized fibers. This is because high viscosity and low electrical conductivity of the polymer melt coupled with rapid heat loss to the surroundings resulted in solidification of the jet before it had been significantly stretched by the electric field. In our study, we utilize a model for non‐isothermal melt electrospinning in the presence of a volumetric heat source. Our simulation results demonstrate that downstream heating does reduce the fiber diameter, and is therefore a feasible approach for resolving the limitations of melt electrospinning. In addition, our model has also been used to capture the effect of the surrounding temperature, which affects the thinning of the fiber through surface rather than volumetric interactions. Finally, melt electrospinning experiments are utilized to validate the model predictions for downstream heating. © 2017 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2017, 55, 1393–1405
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.