X-ray diffraction and molecular dynamics simulations were used to probe the structures of two families of ionic liquids containing oligoether tails on the cations. Imidazolium and pyrrolidinium bis(trifluoromethylsulfonyl)amide ILs with side chains ranging from 4 to 10 atoms in length, including both linear alkyl and oligo-ethylene oxide tails, were prepared. Their physical properties, such as viscosity, conductivity and thermal profile, were measured and compared for systematic trends. Consistent with earlier literature, a single ether substituent substantially decreases the viscosity of pyrrolidinium and imidazolium ILs compared to their alkyl congeners. Remarkably, as the number of ether units in the pyrrolidinium ILs increases there is hardly any increase in the viscosity, in contrast to alkylpyrrolidinium ILs where the viscosity increases steadily with chain length. Viscosities of imidazolium ether ILs increase with chain length but always remain well below their alkyl congeners. To complement the experimentally determined properties, molecular dynamics simulations were run on the two ILs with the longest ether chains. The results point to specific aspects that could be useful for researchers designing ILs for specific applications. The focus of the ionic liquid (IL) community is shifting beyond the mere measurement of physical properties and identification of trends arising from particular structural moieties. Researchers are delving deeper into the nanostructural interactions between the ions to determine the topographical landscape of the ions within the liquids that influence IL properties.1-3 Such information is valuable when tuning the properties of ILs for particular applications. The ability to tune the properties of ionic liquids for specific applications is a major factor in their allure as remarkable solvents that make it possible to do extreme chemistry without extreme conditions. It has been acknowledged that although ionic liquids have a combination of physical properties that make them attractive alternatives to traditional solvents, they have relatively high viscosities that hamper their practical application in large-scale processes. For example, in the area of electrochemical energy storage devices there is still an urgent need for improved electrolytes exhibiting properties of combustion resistance, high conductivity, and wide electrochemical windows. ILs with improved transport properties (viscosity, conductivity and diffusivity) would be perfect candidates to address this need. Structural modification of the IL cation and anion is a proven tool to dramatically alter IL properties. In particular, substituting ether functionalities for alkyl functionalities on IL cations has been shown to reduce the viscosity of ionic liquids significantly.2,4-6 In this work we examine the effect of incorporating oligoether side chains of varying lengths (1-3 repeating ethoxy units, Figure 1) on the physical properties and structural characteristics of imidazolium and pyrrolidinium NTf 2 ionic liquids in ...
Recently, we have reported a systematic study of photoinduced electron-transfer reactions in ionic liquid solvents using neutral and anionic electron donors and a series of cyano-substituted anthracene acceptors [ Wu , B. ; Maroncelli , M. ; Castner , E. W. Jr Photoinduced Bimolecular Electron Transfer in Ionic Liquids . J. Am. Chem. Soc. 139 , 2017 , 14568 ]. Herein, we report complementary results for a cationic class of 1-alkyl-4-dimethylaminopyridinium electron donors. Reductive quenching of cyano-substituted anthracene fluorophores by these cationic quenchers is studied in solutions of acetonitrile and the ionic liquid 1-ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide. Varying the length of the alkyl chain permits tuning of the quencher diffusivities in solution. The observed quenching kinetics are interpreted using a diffusion-reaction analysis. Together with results from the prior study, these results show that the intrinsic electron-transfer rate constant does not depend on the quencher charge in this family of reactions.
Binary mixtures of ionic liquids (ILs) were prepared and characterized to obtain ILs with viscosity and conductivity properties optimized for use in energy storage devices such as supercapacitors. The bis(trifluoromethylsulfonyl)amide anion (NTf2 -) was the common anion for both ILs in the mixture. Ethoxyethyl was the common substituent on the solute and solvent, as ether substituents have been shown to produce low viscosity ILs. N-Ethoxyethyl-N-methylpyrrolidinium NTf2 was used as the solvent for all of the IL mixtures. The solutes were either monocationic or dicationic and made up 10% of the binary mixture by weight. We report here on the physical properties of the individual ILs and their binary mixtures.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.