Polymeric multichannel hollow fiber membranes were developed to reduce fiber breakage and to increase the volume-to-membrane-surface ratio and consequently the efficiency of filtration processes. These membranes are commonly used in ultrafiltration and are operated in in-out dead-end mode. However, some of the filtration details are unknown. The filtration efficiency and flow in the multichannel membranes depend on filtration time and are expected to vary along spatial coordinates. In the current work, in-situ magnetic resonance imaging was used to answer these questions. Velocities were quantified in the feed channels to obtain a detailed understanding of the filtration process. Flow and deposits were measured in each of the seven channels during filtration of sodium alginate, which is a model substance for extracellular polymeric substances occurring in water treatment. Volume flow and flow profiles were calculated from phase contrast flow images. The flow in zdirection in the center channel was higher than in the surrounding channels. Flow profiles variate depending on the concentration of Ca 2+ , which changes the filtration mechanism of aqueous solutions of sodium alginate from concentration polarization to gel layer filtration.

Ultrafiltration with ceramic hollow fiber membranes was investigated by compressed sensing rapid acquisition relaxation enhancement (CS-RARE) magnetic resonance imaging (MRI) to characterize filtration mechanisms. Sodium alginate was used as a model substance for extracellular polymeric substances. Dependent on the concentration of divalent ions like Ca 21 in an aqueous alginate solution, the characteristics of the filtration change from concentration polarization to a gel layer. The fouling inside the membrane lumen could be measured by MRI with a CS-RARE pulse sequence. Contrast agents have been used to get an appropriate contrast between deposit and feed. The lumen was analyzed quantitatively by exploring the membrane's radial symmetry, and the resulting intensity could be modeled. Thus, different fouling mechanisms could be distinguished. CS-RARE-MRI was proven to be an appropriate in situ tool to quantitatively characterize the deposit formation during in-out filtration processes. The results were underlined by flux interruption experiments and length dependent studies, which make it possible to differentiate between gel layer or cake filtration and concentration polarization filtration processes.

Paramagnetic polyoxometalates are of special interest with regard to their application as alternative contrast agents in nonhuman magnetic resonance imaging which is increasingly used in materials science and process engineering.

Filtration and separation via membranes are key processes in food processing. One major application of membrane filtration is in the dairy industry, aiming for the separation of different milk proteins. The various chemical components of milk possess different physiochemical properties and can be used most effectively in food processing if they are separately available and remain in their native state. Microfiltration of skim milk allows a fractionation of the milk proteins casein and whey by size. A deposit is formed on the membrane surface mainly but not exclusively by micellar casein proteins during filtration. Membrane pore blockage by whey proteins and fouling occur during membrane filtration, negatively affecting the yield of the whey protein fraction. Skim milk filtration and the deposit layer formation were measured time and spatially resolved by in situ magnetic resonance imaging (MRI). The nature of the fouling layer was investigated during dead‐end filtration in ceramic hollow fiber membranes. MRI was used to further clarify the influence of operating conditions on separation and filtration mechanisms that are responsible for growth of the fouling layer and its reversibility. The MRI measurements were analyzed for a detailed description of skim milk filtration by modeling the signal intensity distribution.