This study is based to a new concept, to use maize stalk for specific sorption and recovery of Cu(II) and Fe(III) from synthetic solutions. Thus, the sorption properties of the biomass resulting from the recycling of the maize stalk that reached maturity (autumn) were studied. In the first stage, the sorption properties of the maize stalk were evaluated in batch system. Moreover, in terms of water quality improvement several key parameters that influence the sorption equilibrium were evaluated. The effect of contact time (0-120min) and cations initial concentration (investigated range: 0.05-0.4 mg/L) on biomaterial sorption capacity were assessed. Kinetic studies were performed taking into consideration the initial concentration of metallic cation. The experimental data were analyzed based on first order kinetic model, pseudo-second-kinetic model and Morris Webber kinetic model. The kinetics of sorption was in accordance with the pseudo - second - kinetic model as the correlation coefficients showed (R2=0.9940 for Cu(II) and R2=0.9999 for Fe(III)). Moreover the desorption study was evaluated with hydrochloric acid and have detected to be 63% and 89% for Cu(II) and Fe(III) when 4M HCl is used. The surface of the maize stalk loaded with Cu(II) and Fe(III) was characterized by various specific techniques such as FTIR-ATR, SEM, and TG. Experimental results revealed that cations sorption process takes place on the sorbent surface. The sorption rate of each metallic cation is controlled by the formation of chemical bonds with surface polar groups. Their presence on biomass structure, evidenced by FTIR-ATR analysis, explains the behavior of maize stalk as a weak ion exchanger acid.
New research applications involving the use of cellulosic material derived from maize stalk for on-site treatment of leachate were evaluated for specific removal of Cu(II) and Fe(III) from real, highly polluted tailing pond and mine wastewater samples. Two major issues generated by anthropic mining activities were also tackled: wastewater metal content decrease to improve water quality and subsequently metal specific recovery, increasing the economic efficiency of metal production by using a green technology for residual management. Rapid saturation of the maize stalk mass determined in batch studies and the mine pilot experiment led to diminished metal concentrations in the second pilot experiment, where Cu(II) and Pb(II) from synthetic solutions were monitored in order to test biomaterial performances. In addition, in the second pilot experiment, maize stalk removed Pb(II) in the first 36 h, below the determination limit of the analytical method. The biomaterial bed in the column was saturated after 252 h of inflow solution. FTIR-ATR, TG and SEM techniques probed the interaction between maize stalk polar groups C=O, –OH, C–O and tailing water metallic ions by large FTIR band displacements, intensity decrease and shape changes, modification of thermal stability and by changes in the appearance of adsorbent microstructure images owing mainly to ion exchange mechanism.
In the present paper we report, a series of experimental characterization and analysis models that can be applied to industrial waste samples in order to determine the heavy metals within them. During our studies we determined that both preparation and pretreatment of the waste sample are the two most important steps in the analysis process. Therefore, an increased attention was given in using appropriate procedures and methods for preparation and pretreatment. In order to ensure a correct and secure analysis were developed experimental models based on preparation and pretreatment stages and also on organic matrix decomposition method (digestion process with acid mixture under microwave). These experimental models were tested on a series of wastes coming from processing and finishing activities of metal surfaces and other materials. Metal concentration was analyzed by AAS (atomic absorption spectrometry) and XRF (X-ray fluorescence spectrometry). The obtained results proved that the proposed experimental models are suitable for analysis of different types of industrial wastes samples.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.