Residual stresses occur in many manufactured structures and components. Large number of investigations have been carried out to study this phenomenon and its effect on the mechanical characteristics of these components.Over the years, different methods have been developed to measure residual stress for different types of components in order to obtain reliable assessment. The various specific methods have evolved over several decades and their practical applications have greatly benefited from the development of complementary technologies, notably in material cutting, full-field deformation measurement techniques, numerical methods and computing power. These complementary technologies have stimulated advances not only in measurement accuracy and reliability, but also in range of application; much greater detail in residual stresses measurement is now available. This paper aims to classify the different residual stresses measurement methods and to provide an overview of some of the recent advances in this area to help researchers on selecting their techniques among destructive, semi destructive and non destructive techniques depends on their application and the availabilities of those techniques. For each method scope, physical limitation, advantages and disadvantages are summarized. In the end this paper indicates some promising directions for future developments.

Laser process parameters influence greatly the width of kerfs and quality of the cut edges. This article reports experiments on the laser plywood-cutting performance of a CW 1.5 kW CO 2 Rofin laser, based on design of experiments (DOE). The laser was used to cut three thicknesses 3, 6 and 9 mm of plywood panels. The process factors investigated are: laser power, cutting speed, air pressure and focal point position. The aim of this work is to relate the cutting edge quality parameters namely: upper kerf (UK), lower kerf (LK), the ratio between upper to lower kerfs and the operating cost to the process parameters mentioned above. Mathematical models were developed to establish the relationship between the process parameters and the edge quality parameters, and special graphs were drawn for this purpose. Finally, a numerical optimization was performed to find out the optimal process setting at which both kerfs would lead to a ratio of about 1, and at which low cutting cost take place.