The behavior of a very slender building is investigated under wind loads, to satisfy both strength and serviceability (comfort) design criteria. To evaluate the wind effects, wind tunnel testing and structural analysis were conducted, by two different procedures: (i) Pressure Integration Method (PIM), with finite element modeling, and (ii) High Frequency Force Balance (HFFB) technique. The results from both approaches are compared with those obtained from Eurocode 1 and the Italian design codes, emphasizing the need to further deepen the understanding of problems related to wind actions on such type of structure with high geometrical slenderness. In order to reduce wind induced effects, structural and damping solutions are proposed and discussed in a comparative study. These solutions include (1) height reduction, (2) steel belts, (3) tuned mass damper, (4) viscous dampers, and (5) orientation change. Each solution is studied in detail, along with its advantages and limitations, and the reductions in the design loads and structural displacements and acceleration are quantified. The study shows the potential of damping enhancement in the building to mitigate vibrations and reduce design loads and hence provide an optimal balance among resilience, serviceability, and sustainability requirements.

No abstract

No abstract

No abstract

Over the last few decades, the attention on the safety of existing reinforced concrete (RC) structures has significantly increased. RC bridges, in particular, are highly relevant for strategic importance. In the Italian context, several of these bridges were built around 1960, when engineering practice commonly ignored or underestimated the presence of seismic actions. Therefore, it is fundamental to quantify as accurately as possible their seismic safety level with state-of-the-art analysis techniques. In this paper, an efficient procedure based on the multi-modal pushover analysis approach is proposed for the risk evaluation of several bridges of the Italian highway network. This procedure, tailored for portfolio level assessment, takes into account the non-linear behavior and the complex dynamic response this type of structure with limited computational effort. Three fundamental aspects are defined for the structural modelling of bridges, i.e., materials’ constitutive law, finite element type and nonlinear hinge models. Flexural and shear nonlinearities of piers are included to account for ductile and brittle damage potential. The standardized procedure guarantees consistent comparisons among different bridges of the same network in the form of risk indexes.