A method for hyphenating surface enhanced Raman scattering (SERS) and thin-layer chromatography (TLC) is presented that employs silver-polymer nanocomposites as an interface. Through the process of conformal blotting, analytes are transferred from TLC plates to nanocomposite films before being imaged via SERS. A procedure leading to maximum blotting efficiency was established by investigating various parameters such as time, pressure, and type and amount of blotting solvent. Additionally, limits of detection were established for test analytes malachite green isothiocyanate, 4-aminothiophenol, and Rhodamine 6G (Rh6G) ranging from 10(-7) to 10(-6) M. Band broadening due to blotting was minimal (∼10%) as examined by comparing the spatial extent of TLC-spotted Rh6G via fluorescence and then the SERS-based spot size on the nanocomposite after the blotting process. Finally, a separation of the test analytes was carried out on a TLC plate followed by blotting and the acquisition of distance × wavenumber × intensity three-dimensional TLC-SERS plots.

We introduce a chemical sensing technology, named ChIMES (Chemical Identification through Magneto-Elastic Sensing), that can detect a broad range of targets and that has the capability of untethered communication through a metallic or nonmetallic barrier. These features enable many applications in which penetrations into the sampled environment are unwanted or infeasible because of health, safety, or environmental concerns, such as following the decomposition of a dangerous material in a sealed container. The sensing element is passive and consists of a target response material hard-coupled to a magnetoelastic wire. When the response material encounters a target, it expands, imposing mechanical stress on the wire and altering its magnetic permeability. Using a remote excitation-detection coil set, the changes in permeability are observed by switching the magnetic domains in the wire and measuring the modifications in the Faraday voltage as the stress is varied. Sensors with different response materials can be arrayed and interrogated individually. We describe the sensor and its associated instrumentation, compare the performance of several types of wire, and evaluate analytical metrics of single and arrayed ChIMES sensors against a suite of volatile organic compounds.

An advantage of separation platforms based on deterministic micro- and nano-fabrications, relative to traditional systems based on packed beds of particles, is the exquisite control of all morphological parameters. For example, with planar platforms based on lithographically-prepared pillar arrays, the size, shape, height, geometric arrangement, and inter pillar gaps can be independently adjusted. Since the inter pillar gap is expected to be important in determining resistance to mass transfer in the mobile phase as well as the flow rate, which influences the mass transfer effect and axial diffusion, we herein study the effect of reducing inter pillar gaps on capillary action-based flow and band dispersion. Atomic layer deposition is used to narrow the gap between the pillars for photo-lithographically defined pillar arrays. The plate height of gap-adjusted arrays is modeled based on predicted and observed flow rates. A reduction in the flow rate with smaller gaps hinders the efficiency in the modeled case and is correlated with actual separations. A conclusion is drawn that simultaneously reducing both the gap and the pillar diameter is the best approach in terms of improving the chromatographic efficiency.