Injection of photoexcited electrons from colloidal PbS quantum dots into TiO(2) nanoparticles is investigated. The electron affinity and ionization potential of PbS quantum dots, inferred from cyclic voltammetry measurements, show strong size dependence due to quantum confinement. On the basis of the measured energy levels, photoexcited electrons should transfer efficiently from the quantum dots into TiO(2) only for quantum-dot diameter below approximately 4.3 nm. Continuous-wave fluorescence spectra and fluorescence transients of PbS quantum dots coupled to titanium dioxide nanoparticles are consistent with electron transfer for small quantum dots. The measured electron transfer time is surprisingly slow ( approximately 100 ns), and implications of this for future photovoltaics will be discussed. Initial results obtained from solar cells sensitized with PbS quantum dots are presented.

Photonic bandgap structures use the principle of interference to reflect radiation. Reflection from photonic bandgap structures has been demonstrated in one, two and three dimensions and various applications have been proposed. Early work in hollow-core photonic bandgap fibre technology used a hexagonal structure surrounding the air core; this fibre was the first demonstration of light guided inside an air core of a photonic bandgap fibre. The potential benefits of guiding light in air derive from lower Rayleigh scattering, lower nonlinearity and lower transmission loss compared to conventional waveguides. In addition, these fibres offer a new platform for studying nonlinear optics in gases. Owing largely to challenges in fabrication, the early air-core fibres were only available in short lengths, and so systematic studies of loss were not possible. More recently, longer lengths of fibre have become available with reported losses of 1,000 dB km(-1). We report here the fabrication and characterization of long lengths of low attenuation photonic bandgap fibre. Attenuation of less than 30 dB km(-1) over a wide transmission window is observed with minimum loss of 13 dB km(-1) at 1,500 nm, measured on 100 m of fibre. Coupling between surface and core modes of the structure is identified as an important contributor to transmission loss in hollow-core photonic bandgap fibres.

The properties of an oxyfluoride glass ceramic that possesses high transparency after ceramming are described. Approximately 25 vol % of this material is comprised of cubic, fluoride nanocrystals and the remainder is a predominantly oxide glass. When doped with Pr+3, the fluorescence lifetime at 1300 nm is longer than in a fluorozirconate glass, suggesting that a significant fraction of the rare-earth dopant is preferentially partitioned into the fluoride crystal phase. This material has the added advantage of being compatible with ambient air processing.

No abstract

A directional coupler written in a glass sample by the focused 400-nm output from a 25-fs oscillator is reported. The coupler is single mode; the splitting ratio is 1.9 dB at 633 nm. A refractive-index profile of the waveguide with a magnitude of Dn = 4.5 x 10(-3) was retrieved from a near-field mode pattern.