There have been multiple conflicting reports about the biocompatibility and antimicrobial activity of graphene oxide. To address this, we conducted a study to characterize the antimicrobial properties of graphene oxide (GO) and its biocompatibility with mammalian cells. When GO was added to a bacterial culture at 25 μg/mL, the results showed that bacteria grew faster and to a higher optical density than cultures without GO. Scanning electron microscopy indicated that bacteria formed dense biofilms in the presence of GO. This was shown by a large mass of aggregated cells and extracellular polymeric material. Bacterial growth on filters coated with 25 and 75 μg of GO grew 2 and 3 times better than on filters without GO. Closer analysis showed that bacteria were able to attach and proliferate preferentially in areas containing the highest GO levels. Graphene oxide films failed to produce growth inhibition zones around them, indicating a lack of antibacterial properties. Also, bacteria were able to grow on GO films to 9.5 × 10(9) cells from an initial inoculation of 1.0 × 10(6), indicating that it also lacks bacteriostatic activity. Thus, silver-coated GO films were able to produce clearing zones and cell death. Also, graphene oxide was shown to greatly enhance the attachment and proliferation of mammalian cells. This study conclusively demonstrates that graphene oxide does not have intrinsic antibacterial, bacteriostatic, and cytotoxic properties in both bacteria and mammalian cells. Furthermore, graphene oxide acts as a general enhancer of cellular growth by increasing cell attachment and proliferation.

No abstract

This work describes a novel method for the preparation of titanium oxide nanoparticles supported on amorphous carbon with nanoporosity (Ti/NC) via the post-synthetic modification of a Zn-based MOF with an amine functionality, IRMOF-3, with titanium isopropoxide followed by its carbothermal pyrolysis. This material exhibited high purity, high surface area (>1000 m(2)/g), and a high dispersion of metal oxide nanoparticles while maintaining a small particle size (~4 nm). The material was shown to be a promising catalyst for oxidative desulfurization of diesel using dibenzothiophene as a model compound as it exhibited enhanced catalytic activity as compared with titanium oxide supported on activated carbon via the conventional incipient wetness impregnation method. The formation mechanism of Ti/NC was also proposed based on results obtained when the carbothermal reduction temperature was varied.

Tetherball: A heterogeneous, mesoporous silica‐tethered iridium catalyst (Ir‐PN/SBA‐15) containing a bidentate iminophosphine ligand is synthesized for the hydrogenation of CO2 to formic acid in aqueous solution. This new recyclable catalyst exhibits high activities to formic acid production under mild conditions [60 °C, 4.0 MPa total pressure (H2/CO2=1:1)].

Titanium-based microporous heterogeneous catalysts are widely studied but are often limited by the accessibility of reactants to active sites. Metal-organic frameworks (MOFs), such as MIL-125 (Ti), exhibit enhanced surface areas due to their high intrinsic microporosity, but the pore diameters of most microporous MOFs are often too small to allow for the diffusion of larger reactants (>7 Å) relevant to petroleum and biomass upgrading. In this work, hierarchical microporous MIL-125 exhibiting significantly enhanced interparticle mesoporosity was synthesized using a chelating-free, vapor-assisted crystallization method. The resulting hierarchical MOF was examined as an active catalyst for the oxidation of dibenzothiophene (DBT) with tert-butyl hydroperoxide and outperformed the solely microporous analogue. This was attributed to greater access of the substrate to surface active sites, as the pores in the microporous analogues were of inadequate size to accommodate DBT. Moreover, thiophene adsorption studies suggested the mesoporous MOF contained larger amounts of unsaturated metal sites that could enhance the observed catalytic activity.