We report quantitative, real-time, online observations of microscopic viscosity changes in aerosol particles of atmospherically relevant composition, using fluorescence lifetime imaging (FLIM) of viscosity.

Encapsulated microbubbles are well established as highly effective contrast agents for ultrasound imaging. There remain, however, some significant challenges to fully realize the potential of microbubbles in advanced applications such as perfusion mapping, targeted drug delivery, and gene therapy. A key requirement is accurate characterization of the viscoelastic surface properties of the microbubbles, but methods for independent, nondestructive quantification and mapping of these properties are currently lacking. We present here a strategy for performing these measurements that uses a small fluorophore termed a "molecular rotor" embedded in the microbubble surface, whose fluorescence lifetime is directly related to the viscosity of its surroundings. We apply fluorescence lifetime imaging to show that shell viscosities vary widely across the population of the microbubbles and are influenced by the shell composition and the manufacturing process. We also demonstrate that heterogeneous viscosity distributions exist within individual microbubble shells even with a single surfactant component.

The viscosity of atmospheric aerosol particles affects a number of key physical and chemical particle properties, such as composition and reactivity. However, determination of the microscopic viscosity of aerosol particles is a non-trivial task. We report a new method of imaging viscosity in a variety of model aerosol systems, based on a fluorescence lifetime determination of viscosity-sensitive fluorophores termed molecular rotors. We report the viscosity changes associated with the relative humidity dependent hygroscopicity of NaCI and sucrose aerosols, as well as reaction dependent changes in viscosity during ozonolysis of oleic acid aerosols. The Fluorescence Lifetime Imaging Microscopy (FLIM) of molecular rotors shows great promise in understanding important fundamental aerosol properties, which can be both time-dependent and spatially variable through the aerosol particle.

We utilize the fluorescent molecular rotor Bodipy-C12 to investigate the viscoelastic properties of hydrophobic layers of bacterial spores Bacillus subtilis. The molecular rotor shows a marked increase in fluorescence lifetime, from 0.3 to 4ns, upon viscosity increase from 1 to 1500cP and can be incorporated into the hydrophobic layers within the spores from dormant state through to germination. We use fluorescence lifetime imaging microscopy to visualize the viscosity inside different compartments of the bacterial spore in order to investigate the inner membrane and relate its compaction to the extreme resistance observed during exposure of spores to toxic chemicals. We demonstrate that the bacterial spores possess an inner membrane that is characterized by a very high viscosity, exceeding 1000cP, where the lipid bilayer is likely in a gel state. We also show that this membrane evolves during germination to reach a viscosity value close to that of a vegetative cell membrane, ca. 600cP. The present study demonstrates quantitative imaging of the microscopic viscosity in hydrophobic layers of bacterial spores Bacillus subtilis and shows the potential for further investigation of spore membranes under environmental stress.

We report the synthesis of four new cationic dipolar push-pull dyes, together with an evaluation of their photophysical and photobiological characteristics pertinent for imaging membranes by fluorescence and second harmonic generation. All four dyes consist of an N,N-diethylaniline electron-donor conjugated to a pyridinium electron-acceptor via a thiophene bridge, with either vinylene (-CH=CH-) or ethynylene 10 (-CC-) linking groups, and with either singly-charged or doubly-charged pyridinium terminals. The absorption and fluorescence behavior of these dyes was compared to a commercially available fluorescent membrane stain, the styryl dye FM4-64. The hyperpolarizabilities of all dyes were compared using hyper-Rayleigh scattering at 800 nm. Cellular uptake, localization, toxicity and phototoxicity were evaluated using tissue cell cultures (HeLa, SK-OV-3 and MDA-231). Replacing the central alkene bridge 15 of FM4-64 with a thiophene does not substantially change the absorption, fluorescence or hyperpolarizability, whereas changing the vinylene-links to ethynylenes shifts the absorption and fluorescence to shorter wavelengths, and reduces the hyperpolarizability by about a factor of two. SHG and fluorescence imaging experiments in live cells showed that the doubly-charged thiophene dyes localize in plasma membranes, and exhibit lower internalization rates compared to FM4-64, resulting in 20 less signal from the cell cytosol. At a typical imaging concentration of 1 µM, the doubly-charged dyes showed no significant light or dark toxicity, whereas the singly-charged dyes are phototoxic even at 0.5 µM, and toxic in the dark at concentrations above 5 µM. The doubly-charged dyes showed phototoxicity at concentrations greater than 10 µM, although they do not generate singlet oxygen, indicating that the phototoxicity is type I rather than type II. Our data demonstrate that the doubly-charged thiophene dyes 25 are more effective than FM4-64 as nonlinear optical imaging agents for live cells.