A series of 0−3 metal oxide−polyolefin nanocomposites are synthesized via in situ olefin polymerization, using the following single-site metallocene catalysts: C 2-symmetric dichloro[rac-ethylenebisindenyl]zirconium(IV), Me2Si( t BuN)(η5-C5Me4)TiCl2, and (η5-C5Me5)TiCl3 immobilized on methylaluminoxane (MAO)-treated BaTiO3, ZrO2, 3-mol %-yttria-stabilized zirconia, 8-mol %-yttria-stabilized zirconia, sphere-shaped TiO2 nanoparticles, and rod-shaped TiO2 nanoparticles. The resulting composite materials are structurally characterized via X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), 13C nuclear magnetic resonance (NMR) spectroscopy, and differential scanning calorimetry (DSC). TEM analysis shows that the nanoparticles are well-dispersed in the polymer matrix, with each individual nanoparticle surrounded by polymer. Electrical measurements reveal that most of these nanocomposites have leakage current densities of ∼10−6−10−8 A/cm2; relative permittivities increase as the nanoparticle volume fraction increases, with measured values as high as 6.1. At the same volume fraction, rod-shaped TiO2 nanoparticle−isotactic polypropylene nanocomposites exhibit significantly greater permittivities than the corresponding sphere-shaped TiO2 nanoparticle−isotactic polypropylene nanocomposites. Effective medium theories fail to give a quantitative description of the capacitance behavior, but do aid substantially in interpreting the trends qualitatively. The energy storage densities of these nanocomposites are estimated to be as high as 9.4 J/cm3.
The activity of an yttrium alkoxide complex supported by a ferrocene-based ligand was controlled using redox reagents during the ring-opening polymerization of L-lactide. The oxidized complex was characterized by X-ray crystallography and (1)H NMR, XANES, and Mössbauer spectroscopy. Switching in situ between the oxidized and reduced yttrium complexes resulted in a change in the rate of polymerization of L-lactide. Synthesized polymers were analyzed by gel permeation chromatography. Polymerization of trimethylene carbonate was also performed with the reduced and oxidized forms of an indium alkoxide complex. The indium system showed the opposite behavior to that of yttrium, revealing a metal-based dependency on the rate of polymerization.
Atomic layer deposition (ALD) is used to deposit ruthenium-platinum nanostructured catalysts using 2,4-(dimethylpentadienyl)(ethylcyclopentadienyl) ruthenium, trimethyl(methylcyclopentadienyl) platinum, and oxygen as precursors. Transmission electron microscopy shows discrete 1.2 nm nanoparticles decorating the surface of the spherical alumina support. The Ru-Pt particles are crystalline and have a crystal structure similar to pure platinum. X-ray fluorescence measurements show that the nanoparticle composition is controlled by the ratio of metal precursor ALD cycles. X-ray absorption spectroscopy at the Ru K-edge indicates a nearest neighbor Ru-Pt interaction consistent with a bimetallic composition. Methanol decomposition reactions further confirm a Ru-Pt interaction and show enhanced methanol conversion for the bimetallic nanoparticles when compared to catalysts comprised of a mixture of pure Pt and Ru nanoparticles of similar loading. These results demonstrate that ALD is a viable technique for synthesizing mixed-metal nanostructures suitable for catalysis and other applications.
The activity of cerium alkoxide complexes supported by a Schiff base ligand was controlled using redox reagents during the ring-opening polymerization of L-lactide. The rate of L-lactide polymerization was modified by switching in situ between the cerium(III) and cerium(IV) species.
Structural characterization of the catalytically significant sites on solid catalyst surfaces is frequently tenuous because their fraction, among all sites, typically is quite low. Here we report the combined application of solid-state 13 C-cross-polarization magic angle spinning nuclear magnetic resonance ( 13 C-CPMAS-NMR) spectroscopy, density functional theory (DFT), and Zr X-ray absorption spectroscopy (XAS) to characterize the adsorption products and surface chemistry of the precatalysts (η 5 O rganometallic molecule-derived heterogeneous catalysts are of increasing interest owing to their enhanced thermal stability and activity vs. their homogeneous analogs, and their atomically precise tailorable metal-ligand structures vs. other heterogeneous catalysts (1, 2). Furthermore, it is becoming increasingly evident that the inorganic support in many systems is noninnocent and can function as both a ligand and an activator, with the chemically important but poorly understood nature of the catalyst-support interaction strongly modulating catalytic activity and selectivity (3, 4). When adsorbed on Lewis acidic, dehydroxylated alumina surfaces, group 4 complexes such as Cp 2 ZrR 2 (Cp = η 5 -C 5 H 5 ; A, R = H; B, R = CH 3 ) and Cp*Zr (CH 3 ) 3 [C, Cp* = η 5 -C 5 (CH 3 ) 5 ] were argued on the basis of highresolution solid-state NMR spectroscopy to transfer an alkyl anion to unsaturated, Lewis acidic surface sites as in Fig. 1 (complexes B, C → qualitative model D) (5, 6). The resulting catalysts are extremely active for olefin hydrogenation and polymerization, and analogous ion-paired species form the basis for large-scale industrial polymerization processes (7,8). However, kinetic poisoning experiments in which the catalytic sites are titrated in situ with H 2 O or t BuCH 2 OH indicate that ≤5% of D-type sites are catalytically significant, likely reflecting, among other factors, the established heterogeneity of alumina surfaces (5, 6, 9), hence rendering active site structural and chemical descriptions necessarily imprecise. In contrast to these results, chemisorption of such organozirconium precursors on SiO 2 , Al 2 O 3 , and SiO 2 -Al 2 O 3 surfaces having appreciable coverage by weakly acidic OH groups predominantly yields covalently bound, poorly electrophilic Etype species via Zr-CH 3 protonolysis with CH 4 evolution (5, 6, 10, 11). Although the E-type sites may be characterized in some detail by high-resolution solid-state NMR and extended X-ray adsorption fine structure spectroscopy (EXAFS), they display minimal catalytic turnover in the absence of added, complicating activators [e.g., methylalumoxane or B(C 6 F 5 ) 3 ], and the fraction of catalytically significant sites is unknown (12, 13). In such situations, it is experimentally impossible to unambiguously distinguish catalytically significant sites from inactive "spectator" sites, hence to fully understand the catalytic chemistry.-In marked contrast to the above results, chemisorption of these same organozirconium molecules on highly Brønsted "super...
This communication reports the styrene homopolymerization behavior and ethylene-styrene copolymerization behavior of the covalently linked bimetallic constrained geometry catalyst (mu-CH2CH2-3,3'){(eta5-indenyl)[1-Me2Si(tBuN)](TiMe2)}2 (Ti2), which is the first single-site catalyst that effects not only styrene homopolymerization with high activity, but also efficient ethylene-styrene copolymerization over a broad styrene composition range (0-76% at 20 degrees C, 1.0 atm ethylene pressure). In styrene homopolymerization, a 50x increase in polymerization activity is achieved with Ti2 vs the mononuclear analogue, Ti1, using an identical trityl borate cocatalyst and polymerization conditions. In ethylene + styrene copolymerization, Ti2 enchains approximately 20% more styrene than Ti1 under identical reaction conditions. 13C NMR spectroscopy indicates that greater than two consecutive styrene units are enchained in the copolymer backbone produced by Ti2 + Ph3C+B(C6F5)4-. End group analysis of the styrene homopolymer produced by Ti2 + Ph3C+B(C6F5)4- suggests that 1,2-regiochemistry is installed in approximately 50% of the initiation steps. This unusual microstructure is believed to be related to the bimetallic catalyst structure.
The 0−3 metal oxide−isotactic polypropylene nanocomposites are synthesized via in situ propylene polymerization using the C 2-symmetric metallocene catalyst dichloro[rac-ethylenebisindenyl]zirconium(IV) (EBIZrCl2) immobilized on methylaluminoxane (MAO)-treated barium titanate (BaTiO3) or titanium dioxide (TiO2) nanoparticles. The composite materials are characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and 13C nuclear magnetic resonance (NMR) spectroscopy. It is shown that the nanoparticles are homogeneously dispersed in the polyolefin matrices. Electrical measurements reveal nanocomposite leakage current densities of ∼10-6 to 10-9 A/cm2, permittivities as high as 6.1, and breakdown strengths of ∼4 MV/cm. Energy densities are estimated to be as high as 9.4 J/cm3.
Two series of Schiff base metal complexes were investigated, where each series was supported by an ancillary ligand incorporating a ferrocene backbone and different N=X functionalities. One ligand is based on an imine, while the other is based on an iminophosphorane group. Cerium(IV), cerium(III), and yttrium(III) alkoxide complexes supported by the two ligands were synthesized. All metal complexes were characterized by cyclic voltammetry. Additionally, NMR, Mössbauer, X-ray absorption near-edge structure (XANES), and absorption spectroscopies were used. The experimental data indicate that iron remains in the +2 oxidation state and that cerium(IV) does not engage in a redox behavior with the ancillary ligand.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.