Space-division multiplexing (SDM) uses multiplicity of space channels to increase capacity for optical communication. It is applicable for optical communication in both free space and guided waves. This paper focuses on SDM for fiber-optic communication using few-mode fibers or multimode fibers, in particular on the critical challenge of mode crosstalk. Multiple-input-multipleoutput (MIMO) equalization methods developed for wireless communication can be applied as an electronic method to equalize mode crosstalk. Optical approaches, including differential modal group delay management, strong mode coupling, and multicore fibers, are necessary to bring the computational complexity for MIMO mode crosstalk equalization to practical levels. Progress in passive devices, such as (de)multiplexers, and active devices, such as amplifiers and switches, which are considered straightforward challenges in comparison with mode crosstalk, are reviewed. Finally, we present the prospects for SDM in optical transmission and networking.

Abstract:We demonstrate mode-division multiplexed WDM transmission over 50-km of few-mode fiber using the fiber's LP 01 and two degenerate LP 11 modes. A few-mode EDFA is used to boost the power of the output signal before a few-mode coherent receiver. A 6×6 time-domain MIMO equalizer is used to recover the transmitted data. We also experimentally characterize the 50-km few-mode fiber and the few-mode EDFA.

Using multimode fibers for long-haul transmission is proposed and demonstrated experimentally. In particular few-mode fibers (FMFs) are demonstrated as a good compromise since they are sufficiently resistant to mode coupling compared to standard multimode fibers but they still can have large core diameters compared to single-mode fibers. As a result these fibers can have significantly less nonlinearity and at the same time they can have the same performance as single-mode fibers in terms of dispersion and loss. In the absence of mode coupling it is possible to use these fibers in the single-mode operation where all the data is carried in only one of the spatial modes throughout the fiber. It is shown experimentally that the single-mode operation is achieved simply by splicing single-mode fibers to both ends of a 35-km-long dual-mode fiber at 1310 nm. After 35 km of transmission, no modal dispersion or excess loss was observed. Finally the same fiber is placed in a recirculating loop and 3 WDM channels each carrying 6 Gb/s BPSK data were transmitted through 1050 km of the few-mode fiber without modal dispersion.

In this paper, the concept of supermode is introduced for long-distance optical transmission systems. The supermodes exploit coupling between the cores of a multi-core fiber, in which the core-to-core distance is much shorter than that in conventional multi-core fiber. The use of supermodes leads to a larger mode effective area and higher mode density than the conventional multi-core fiber. Through simulations, we show that the proposed coupled multi-core fiber allows lower modal dependent loss, mode coupling and differential modal group delay than few-mode fibers. These properties suggest that the coupled multi-core fiber could be a good candidate for both spatial division multiplexing and single-mode operation.

We propose a method for controlling modal gain in a multimode Erbium-doped fiber amplifier (MM-EDFA) by tuning the mode content of a multimode pump. By adjusting the powers and orientation of input pump modes, modal dependent gain can be tuned over a large dynamic range. Performance impacts due to excitation of undesired pump modes, mode coupling and macro-bending loss within the erbium-doped fiber are also investigated. The MM-EDFA may potentially be a key element for long haul mode-division multiplexed transmission.

No abstract

Few-mode fibers (FMFs) are used for the first time to transmit over 5000 km. Ten WDM channels with 50GHz channel spacing at 112 Gb/s per channel using PDM-QPSK are launched into the fundamental mode of the FMFs by splicing single-mode fibers directly to the FMFs. Even though few-mode fibers can support an additional spatial mode LP(11) at 1550 nm, the signal remains in the fundamental mode and does not experience mode coupling throughout fiber transmission. After each span the signal is collected by a second single-mode fiber which is also spliced to the FMF. Span loss is compensated by single-mode EDFAs before it is launched to the next FMF span. The lack of mode coupling ensures that the signal does not suffer any impairments that may result from differential mode delay or excess loss. Therefore the FMFs used in this "single-mode operation" have the same bandwidth as single-mode fibers. Experimental results verified that FMFs have the significant advantage of large core size which reduces the nonlinear impairments suffered by the signal. It is shown that FMFs with an effective area of 130 μm(2), have an optimum launch power 2 dB higher compared to standard single-mode fibers and as a result a 1.1 dB improvement in the Q-factor is obtained after 3000 km.

We propose a method for controlling modal gain in a multimode Erbium-doped fiber amplifier (MM-EDFA) by tuning the mode content of a multimode pump. By adjusting the powers and orientation of input pump modes, modal dependent gain can be tuned over a large dynamic range. Performance impacts due to excitation of undesired pump modes, mode coupling and macro-bending loss within the erbium-doped fiber are also investigated. The MM-EDFA may potentially be a key element for long haul mode-division multiplexed transmission.