Compression moulding experiments of sheet moulding compound, visual observations of a vacuum test with prepregs and numerical models with two main approaches for computational fluid dynamics simulations of the mould filling phase are presented. One assumes that there are layers near the mould surfaces with much less viscosity and the other only use one viscosity model. The numerical experiments showed that the pressure could be accurately predicted with both approaches. The property necessary to predict correct pressure with altered mould closing velocities was that the bulk material had to obey shear-thinning effects. Preheating effects before compression were neglected, but altering the heating time until the prepreg was assumed to start flow had a significant effect. The experiments confirmed that the pressure is predominantly affected by the mould closing velocity. Regardless of the considered process settings, a first pressure top always appeared approximately at the logarithmic strain 0.25. A second top was associated with a slowdown of the press. The location of this was affected by the velocity and the vacuum, the latter indicating that vacuum assistance prevents a build-up of back pressure. Furthermore, heated prepreg above a critical temperature is observed to swell immediately as vacuum assistance is applied.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.