Sand production has been highlighted as one of the critical challenges for Zawtika Project. Throughout the years of field experiences, sand production management has brought up many challenges, especially in terms of field potential sustaining, well productivity and investment justification. Alternative sand control technique is one of the keys to overcome these challenges with continuous improvements driven by lessons learnt. Chemical Sand Consolidation (CSC) is the chemical sand control technique using the resin to bond the formation grain and strengthen the formation strength whereas Thru-Tubing Gravel Pack (TTGP) is retrofit sand control method, which the sand control principle is similar to conventional Cased-Hole Gravel Pack (CHGP), but can be installed in a smaller completion size. In Zawtika existing development phases, almost 150 zones of sand producing intervals are handled by CHGP completion design. In addition to CHGP, these mentioned alternative sand control techniques have been successfully implemented in 3.5-inch-tubing monobore completion for selected deep reservoir intervals after some degree of depletion. Field trial of CSC and TTGP had been implemented during 2019-2020 with 5 reservoirs in 7 monobore completion wells (4 CSC wells and 3 TTGP wells). All wells showed positive results with no sand production from the post-job production; and with a reasonable increase in Maximum Allowable Sand Free Rate (MASR). Based on well performance monitoring until early of 2022, all 3 TTGP wells as well as 3 CSC wells no longer have any sand production issue. Nevertheless, only 1 CSC well with water production history record prior to CSC implementation shows poorer performance on sand production prevention. Following the positive results of TTGP from the previous campaign in term of sand production prevention and well life extension, 8 more TTGP well candidates have been implemented in early of 2022. At the early phase of production, sand free production has been observed for all wells with 51 mmscfd incremental MASR. With all aspects of technical and fiscal evaluation proven to be successful, sand retention and production performance of CSC and TTGP are continuously monitored to confirm long-term performance efficiency for full application in the future. Zawtika sand management strategy through alternative sand control completion has been improved upon accumulated lesson learns and production experiences. The lesson learns and experiences from both operation and well performance monitoring will be integrated for further improvement for the next implementation phases. Maximizing gas potential through alternative sand control methods is also believed to be the cost-effective approach which strengthens PTTEP's competitive performance.
Although a stimulation technique, the hydraulic fracturing process can also cause damage to the reservoir in a variety of ways. These damage mechanisms cannot be completely eliminated, but by careful examination of their individual characteristics and effects on production, focus can be placed on minimizing the most critical factors. This paper presents the results of a sensitivity study of numerous reservoir properties and operational control variables on fracture effectiveness and production from a fractured gas well. Simulations are based on a newly developed mathematical model for hydraulic fracture propagation and cleanup processes, combined with reservoir simulation. The numerical simulation model considers a three-dimensional reservoir which can either be homogenous or heterogeneous. The created fracture is extended with time and the corresponding leak-off effects on the near wellbore and far-field area are assessed. Two-phase flow equations, both in the fracture and in the surrounding matrix, are used to evaluate behavior during the fracture propagation and production/clean-up periods. The developed simulation model is validated by history matching with actual field performance from a fractured gas well. The history matched results are used as a base case for the study. The sensitivity results show the creation of different leak-off profiles and the effectiveness of corresponding cleanup processes. Results indicate that shut-in time between end of fracture propagation and beginning of flowback is critical due to imbibition of fracturing fluids. Additionally, heterogeneity of the reservoir has a significant effect on cleanup profiles. Not only does that this study provide significant insight into phenomena happening on the fracture face and inside the reservoir, it and the developed simulator can also be used as a tool for hydraulic fracturing design or post-stimulation evaluation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.