These preliminary results demonstrate the sensitivity of the tool to discriminate between the different behaviours of the hoof on the different track surfaces at high speed. Deceleration and vibration of the hoof at impact were reduced on W compared to S, suggesting a better shock-absorbing quality of this track.

SummaryReasons for performing study: Sandy beaches are often considered good training surfaces for trotter horses. However, their biomechanical effects on locomotion are insufficiently documented. Events at hoof impact have mostly been studied under laboratory conditions with accelerometers, but there is lack of data (acceleration, force, movement) on events occurring under every day practical conditions in the field. Objectives: To investigate hoof landing and stride parameters on different tracks (from wet to dry) of a sand beach and on an asphalt road. Methods: The right front hoof of 4 trotter horses was equipped with a triaxial accelerometer and a dynamometric horseshoe. Acceleration and force recordings (10 kHz) were synchronised with a high speed movie (600 Hz). Horses were driven on a sand beach where 3 tracks of decreasing water content had been delimited (from the sea to the shore): firm wet sand (FWS), deep wet sand (DWS) and deep dry sand (DDS). Firm wet sand and DWS were compared at 25 km/h and DDS compared to an asphalt road at 15 km/h. Recordings (10 strides) were randomly repeated 3 times. Statistical differences were tested using a GLM procedure (P<0.05). Results: Main significant results were 1) a decrease in the amplitude of the vertical deceleration (and force) of the hoof during impact on a softer surface (about 59% between DWS and FWS and 95% between DDS and asphalt), 2) a decrease in the longitudinal braking deceleration (and force) on softer grounds (50% for DWS vs. FWS and 55% for DDS vs. asphalt), 3) a decrease in the stride length and an increase in the stride frequency on a softer surface. Conclusions and clinical relevance: Drier sand surfaces reduce shock and impact forces during landing. For daily training, it should, however, be realised that improved damping characteristics are associated with a shorter stride length and a higher stride frequency. evj_277 488..495

No abstract

No abstract

Summary The objective of this study was to mechanically characterise superficial digital flexor tendon (SDFT) lesions. Eight pathological SDFTs, isolated from 6 adult horses, were tested in traction until rupture (at 1 mm/s). The stresses and strains simultaneously undergone by each of the 7 segments of a tendon were determined throughout the test, and the modulus of elasticity of each segment was evaluated from the segmental stress‐strain curve thus obtained. These mechanical data were compared to those obtained on 10 normal SDFTs. After the test, the tendinous segments were submitted to a histological examination in order to characterise the tissues. Three lesional categories (I to III, of increasing maturity), as well as the normal tendinous tissue, were defined and assessed quantitatively according to their extent in the histological sections. The most recent and severe lesions (categories I and II) were correlated with a large degree of hypertrophy (often above 200%) of the corresponding segments, with a resulting decrease in the stress at tendon rupture, and a slight decrease in the strain at tendon rupture in spite of a low modulus of elasticity (low stiffness). In contrast, the adjacent areas, less or not injured, underwent compensatory strains. This relative overstraining was especially critical with category III tissue, often present in the transitional areas between sound and severely injured segments. Here the modulus of elasticity was low whereas the hypertrophy was only slight. Therefore, the corresponding segments seemed to be the most fragile sites, and those most predisposed to recurring injury, in an injured SDFT.

Excessive axial tension is very likely involved in the aetiology of tendon lesions, and the most appropriate indicator of tendon stress state is the true stress, the ratio of instantaneous load to instantaneous cross-sectional area (CSA). Difficulties to measure tendon CSA during tension often led to approximate true stress by assuming that CSA is constant during loading (i.e. by the engineering stress) or that tendon is incompressible, implying a Poisson's ratio of 0.5, although these hypotheses have never been tested.The objective of this study was to measure tendon CSA variation during quasi-static tensile loading, in order to assess the true stress to which the tendon is subjected and its Poisson's ratio. Eight equine superficial digital flexor tendons (SDFT, about 30 cm long) were tested in tension until failure while the CSA of each tendon was measured in its metacarpal part by means of a linear laser scanner. Axial elongation and load were synchronously recorded during the test.CSA was found to linearly decrease with strain, with a mean decrease at failure of -10.7 ± 2.8 % (mean ± standard deviation). True stress at failure was 7.1 to 13.6 % higher than engineering stress, while stress estimation under the hypothesis of incompressibility differed from true stress of -6.6 to 2.3 %. Average Poisson's ratio was 0.55 ± 0.12 and did not significantly vary with load.From these results on equine SDFT it was demonstrated that tendon in axial quasistatic tension can be considered, at first approximation, as an incompressible material.

Summary Five sound mature horses, age 8‐14 years, with toe angles 45.5‐55.0° were placed on a specially designed platform with only the left forelimb weightbearing, which allowed the successive production of 7 different conditions of foot orientation: neutral position (N), 5, 10, 15° heel (H5, H10, H15) and toe (T5, T10, T15) elevation, performed according to 2 different sequences. For each condition, 2 lateromedial radiographs were taken to evaluate the metacarpophalangeal joint (MPJ) and both interphalangeal joint (PIPJ and DIPJ) angles, respectively. In addition, two‐dimensional (2‐D) kinematic recordings, using reflective skin markers placed laterally on the left forelimb joints, were performed. The value of each joint angle (JA) and its angular variation to N (AV) were considered for statistical analysis. For all JA and their AV determined radiographically, the condition effect was significant and the sequence did not influence the differences between conditions. The relationships between the JA and the conditions (in the sequence: T15, T10, T5, N, H5, H10, H15) were overall linear for the 3 joints. The maximal range T15‐H15 was ± mean s.d. 6.9 ± 2.0 for MPJ (dorsal angle decrease), 7.3 ± 1.0° and 29.5 ± 1.8 for PIPJ and DIPJ (palmar angle decrease), respectively. Contrary to JA and in spite of large variations in hoof conformation, AV did not show any significant horse effect. Wide differences were observed between the digital JA measured radiographically and from kinematics, which could be related to cutaneous displacement. Heel elevation induced elbow flexion, whereas a slight extension was observed with toe elevation. These movements, even slight (mean elbow angle amplitude: 3.6 ± 1.3), may have consequences upon flexor tendon tension.

No abstract